pinctrl: sunxi: add new D1 pinctrl support
For the first time since at least the Allwinner A10 SoCs, the D1 (and
related cores) use a new pincontroller MMIO register layout, so we
cannot use our hardcoded, fixed offsets anymore.
Ideally this would all be handled by devicetree and DM drivers, but for
the DT-less SPL we still need the legacy interfaces.
Add a new Kconfig symbol to differenciate between the two generations of
pincontrollers, and just use that to just switch some basic symbols.
The rest is already abstracted enough, so works out of the box.
Signed-off-by: Andre Przywara <andre.przywara@arm.com>
Reviewed-by: Sam Edwards <CFSworks@gmail.com>
Tested-by: Sam Edwards <CFSworks@gmail.com>
Tested-by: Samuel Holland <samuel@sholland.org>
diff --git a/drivers/gpio/sunxi_gpio.c b/drivers/gpio/sunxi_gpio.c
index e3354965..e4463a2 100644
--- a/drivers/gpio/sunxi_gpio.c
+++ b/drivers/gpio/sunxi_gpio.c
@@ -40,10 +40,23 @@
#define GPIO_DAT_REG_OFFSET 0x10
#define GPIO_DRV_REG_OFFSET 0x14
-#define GPIO_DRV_INDEX(pin) (((pin) & 0x1f) >> 4)
-#define GPIO_DRV_OFFSET(pin) ((((pin) & 0x1f) & 0xf) << 1)
+
+/* Newer SoCs use a slightly different register layout */
+#ifdef CONFIG_SUNXI_NEW_PINCTRL
+/* pin drive strength: 4 bits per pin */
+#define GPIO_DRV_INDEX(pin) ((pin) / 8)
+#define GPIO_DRV_OFFSET(pin) (((pin) % 8) * 4)
+
+#define GPIO_PULL_REG_OFFSET 0x24
+
+#else /* older generation pin controllers */
+/* pin drive strength: 2 bits per pin */
+#define GPIO_DRV_INDEX(pin) ((pin) / 16)
+#define GPIO_DRV_OFFSET(pin) (((pin) % 16) * 2)
#define GPIO_PULL_REG_OFFSET 0x1c
+#endif
+
#define GPIO_PULL_INDEX(pin) (((pin) & 0x1f) >> 4)
#define GPIO_PULL_OFFSET(pin) ((((pin) & 0x1f) & 0xf) << 1)