spi: dw: Remove spi_enable_chip
This function does nothing but wrap dw_write.
Signed-off-by: Sean Anderson <seanga2@gmail.com>
Reviewed-by: Jagan Teki <jagan@amarulasolutions.com>
diff --git a/drivers/spi/designware_spi.c b/drivers/spi/designware_spi.c
index 8abcdde..89a8266 100644
--- a/drivers/spi/designware_spi.c
+++ b/drivers/spi/designware_spi.c
@@ -171,17 +171,12 @@
return request_gpio_cs(bus);
}
-static inline void spi_enable_chip(struct dw_spi_priv *priv, int enable)
-{
- dw_write(priv, DW_SPI_SSIENR, (enable ? 1 : 0));
-}
-
/* Restart the controller, disable all interrupts, clean rx fifo */
static void spi_hw_init(struct udevice *bus, struct dw_spi_priv *priv)
{
- spi_enable_chip(priv, 0);
+ dw_write(priv, DW_SPI_SSIENR, 0);
dw_write(priv, DW_SPI_IMR, 0xff);
- spi_enable_chip(priv, 1);
+ dw_write(priv, DW_SPI_SSIENR, 1);
/*
* Try to detect the FIFO depth if not set by interface driver,
@@ -438,7 +433,7 @@
priv->rx_end = priv->rx + priv->len;
/* Disable controller before writing control registers */
- spi_enable_chip(priv, 0);
+ dw_write(priv, DW_SPI_SSIENR, 0);
dev_dbg(dev, "cr0=%08x rx=%p tx=%p len=%d [bytes]\n", cr0, rx, tx,
priv->len);
@@ -455,7 +450,7 @@
dw_write(priv, DW_SPI_SER, 1 << cs);
/* Enable controller after writing control registers */
- spi_enable_chip(priv, 1);
+ dw_write(priv, DW_SPI_SSIENR, 1);
/* Start transfer in a polling loop */
ret = poll_transfer(priv);
@@ -490,7 +485,7 @@
speed = plat->frequency;
/* Disable controller before writing control registers */
- spi_enable_chip(priv, 0);
+ dw_write(priv, DW_SPI_SSIENR, 0);
/* clk_div doesn't support odd number */
clk_div = priv->bus_clk_rate / speed;
@@ -498,7 +493,7 @@
dw_write(priv, DW_SPI_BAUDR, clk_div);
/* Enable controller after writing control registers */
- spi_enable_chip(priv, 1);
+ dw_write(priv, DW_SPI_SSIENR, 1);
priv->freq = speed;
dev_dbg(bus, "speed=%d clk_div=%d\n", priv->freq, clk_div);