imx8qm_dmsse20a1: Improve SPL memory configuration
Currently, building imx8qm_dmsse20a1_defconfig leads to the following
warning:
aarch64-linux-ld.bfd: invalid origin for memory region .sdram
Fix it by using the same SPL memory layout as done in the imx8mq_evk.
Reported-by: Tom Rini <trini@konsulko.com>
Signed-off-by: Fabio Estevam <festevam@denx.de>
Tested-by: Oliver Graute <oliver.graute@kococonnector.com>
diff --git a/configs/imx8qm_dmsse20a1_defconfig b/configs/imx8qm_dmsse20a1_defconfig
index 01eabc4..017a541 100644
--- a/configs/imx8qm_dmsse20a1_defconfig
+++ b/configs/imx8qm_dmsse20a1_defconfig
@@ -20,6 +20,7 @@
CONFIG_SPL_MMC=y
CONFIG_SPL_SERIAL=y
CONFIG_SPL_DRIVERS_MISC=y
+CONFIG_SPL_STACK=0x13e000
CONFIG_SPL=y
CONFIG_SYS_LOAD_ADDR=0x80280000
CONFIG_REMAKE_ELF=y
@@ -32,8 +33,16 @@
CONFIG_BOOTCOMMAND="mmc dev ${mmcdev}; if mmc rescan; then if run loadbootscript; then run bootscript; else if run loadimage; then run mmcboot; else run netboot; fi; fi; else booti ${loadaddr} - ${fdt_addr}; fi"
CONFIG_LOG=y
# CONFIG_DISPLAY_CPUINFO is not set
+CONFIG_SPL_SYS_MALLOC_SIMPLE=y
+# CONFIG_SPL_SHARES_INIT_SP_ADDR is not set
+CONFIG_SPL_SYS_MALLOC=y
+CONFIG_SPL_HAS_CUSTOM_MALLOC_START=y
+CONFIG_SPL_CUSTOM_SYS_MALLOC_ADDR=0x120000
+CONFIG_SPL_SYS_MALLOC_SIZE=0x3000
CONFIG_BOARD_EARLY_INIT_F=y
CONFIG_SPL_MAX_SIZE=0x1f000
+CONFIG_SPL_HAS_BSS_LINKER_SECTION=y
+CONFIG_SPL_BSS_START_ADDR=0x128000
CONFIG_SPL_BSS_MAX_SIZE=0x1000
CONFIG_SPL_BOARD_INIT=y
CONFIG_SPL_POWER_DOMAIN=y