arm: dts: k3-am654: move dummy_clock to root node
The dummy_clock node is used to help the drivers probe the IO needed to
setup consoles and boot media to load firmware into the SoC.
This dummy_clock isn't a device that exists nor does it exist in the
mcu domain. So move it from cbass_mcu to the root node to avoid any
confusion.
Tested-by: Tom Rini <trini@konsulko.com>
Signed-off-by: Bryan Brattlof <bb@ti.com>
Reviewed-by: Nishanth Menon <nm@ti.com>
diff --git a/arch/arm/dts/k3-am654-r5-base-board.dts b/arch/arm/dts/k3-am654-r5-base-board.dts
index 9926981..b27b2b0 100644
--- a/arch/arm/dts/k3-am654-r5-base-board.dts
+++ b/arch/arm/dts/k3-am654-r5-base-board.dts
@@ -30,6 +30,13 @@
ti,sci-host-id = <10>;
bootph-pre-ram;
};
+
+ clk_200mhz: dummy_clock {
+ compatible = "fixed-clock";
+ #clock-cells = <0>;
+ clock-frequency = <200000000>;
+ bootph-pre-ram;
+ };
};
&cbass_mcu {
@@ -51,13 +58,6 @@
mbox-names = "tx", "rx";
bootph-pre-ram;
};
-
- clk_200mhz: dummy_clock {
- compatible = "fixed-clock";
- #clock-cells = <0>;
- clock-frequency = <200000000>;
- bootph-pre-ram;
- };
};
/*