mpc52xx, digsy_mtc_rev5: Fix Linux crash, if no Flash in bank 2
If no Flash is connected to cs1, Linux crashes, because
reg entries are not correct adapted.
Following fix is needed:
- swap base addresses in CONFIG_SYS_FLASH_BANKS_LIST, as
flash bank 1 is on chipselect 0 and flash bank 2 on
chipselect 1
- call fdt_fixup_nor_flash_size() from ft_board_setup()
Signed-off-by: Heiko Schocher <hs@denx.de>
cc: Wolfgang Denk <hs@denx.de>
cc: Werner Pfister <Pfister_Werner@intercontrol.de>
cc: Detlev Zundel <dzu@denx.de>
diff --git a/board/digsy_mtc/digsy_mtc.c b/board/digsy_mtc/digsy_mtc.c
index afb0948..cbfdc9e 100644
--- a/board/digsy_mtc/digsy_mtc.c
+++ b/board/digsy_mtc/digsy_mtc.c
@@ -46,6 +46,7 @@
#include "is42s16800a-7t.h"
#endif
#include <libfdt.h>
+#include <fdt_support.h>
DECLARE_GLOBAL_DATA_PTR;
@@ -415,6 +416,10 @@
ft_delete_node(blob, "mc,rv3029c2");
#endif
#if defined(CONFIG_SYS_UPDATE_FLASH_SIZE)
+#ifdef CONFIG_FDT_FIXUP_NOR_FLASH_SIZE
+ /* Update reg property in all nor flash nodes too */
+ fdt_fixup_nor_flash_size(blob);
+#endif
ft_adapt_flash_base(blob);
#endif
}