mmc: Handle switch error status bit in MMC card status
MMC switch command for unsupported feature (e.g. bus width) sets a switch
error bit in card status. This bit should be checked, and, if it's set,
no access with new controller settings should be performed.
Acked-by: Pantelis Antoniou <panto@antoniou-consulting.com>
Signed-off-by: Andrew Gabbasov <andrew_gabbasov@mentor.com>
diff --git a/drivers/mmc/mmc.c b/drivers/mmc/mmc.c
index 0c9ae5d..bb9014d 100644
--- a/drivers/mmc/mmc.c
+++ b/drivers/mmc/mmc.c
@@ -150,6 +150,8 @@
#endif
return TIMEOUT;
}
+ if (cmd.response[0] & MMC_STATUS_SWITCH_ERROR)
+ return SWITCH_ERR;
return 0;
}
@@ -501,7 +503,7 @@
err = mmc_switch(mmc, EXT_CSD_CMD_SET_NORMAL, EXT_CSD_HS_TIMING, 1);
if (err)
- return err;
+ return err == SWITCH_ERR ? 0 : err;
/* Now check to see that it worked */
err = mmc_send_ext_csd(mmc, ext_csd);
diff --git a/include/mmc.h b/include/mmc.h
index bc11f45..9143efe 100644
--- a/include/mmc.h
+++ b/include/mmc.h
@@ -54,6 +54,7 @@
#define COMM_ERR -18 /* Communications Error */
#define TIMEOUT -19
#define IN_PROGRESS -20 /* operation is in progress */
+#define SWITCH_ERR -21 /* Card reports failure to switch mode */
#define MMC_CMD_GO_IDLE_STATE 0
#define MMC_CMD_SEND_OP_COND 1
@@ -109,6 +110,7 @@
#define SECURE_ERASE 0x80000000
#define MMC_STATUS_MASK (~0x0206BF7F)
+#define MMC_STATUS_SWITCH_ERROR (1 << 7)
#define MMC_STATUS_RDY_FOR_DATA (1 << 8)
#define MMC_STATUS_CURR_STATE (0xf << 9)
#define MMC_STATUS_ERROR (1 << 19)