rockchip: spi: only wait for completion, if transmitting
The logic in the main transmit loop took a bit of reading the TRM to
fully understand (due to silent assumptions based in internal logic):
the "wait until idle" at the end of each iteration through the loop is
required for the transmit-path as each clearing of the ENA register
(to update run-length in the CTRLR1 register) will implicitly flush
the FIFOs... transmisson can therefore not overlap loop iterations.
This change adds a comment to clarify the reason/need for waiting
until the controller becomes idle and wraps the entire check into an
'if (out)' to make it clear that this is required for transfers with a
transmit-component only (for transfers having a receive-component,
completion of the transmit-side is trivially ensured by having
received the correct number of bytes).
The change does not increase execution time measurably in any of my
tests.
Signed-off-by: Philipp Tomsich <philipp.tomsich@theobroma-systems.com>
diff --git a/drivers/spi/rk_spi.c b/drivers/spi/rk_spi.c
index aaf244d..c807d78 100644
--- a/drivers/spi/rk_spi.c
+++ b/drivers/spi/rk_spi.c
@@ -379,9 +379,18 @@
toread--;
}
}
- ret = rkspi_wait_till_not_busy(regs);
- if (ret)
- break;
+
+ /*
+ * In case that there's a transmit-component, we need to wait
+ * until the control goes idle before we can disable the SPI
+ * control logic (as this will implictly flush the FIFOs).
+ */
+ if (out) {
+ ret = rkspi_wait_till_not_busy(regs);
+ if (ret)
+ break;
+ }
+
len -= todo;
}