ARM: dts: stm32: Add support for STM32MP13xx DHCOR SoM and DHSBC rev.200 board
LDO2 is expansion connector supply on STM32MP13xx DHCOR DHSBC rev.200.
LDO5 is carrier board supply on STM32MP13xx DHCOR DHSBC rev.200. Keep
both regulators always enabled to make sure both the carrier board and
the expansion connector is always powered on and supplied with correct
voltage.
Describe ST33TPHF2XSPI TPM 2.0 chip reset lines.
This is a port of Linux kernel patch posted at:
https://patchwork.kernel.org/project/linux-arm-kernel/patch/20250302152605.54792-1-marex@denx.de/
This change shall be removed when the Linux kernel DT change lands
and Linux kernel DTs get synchronized with U-Boot DTs.
Signed-off-by: Marek Vasut <marex@denx.de>
Reviewed-by: Patrice Chotard <patrice.chotard@foss.st.com>
diff --git a/arch/arm/dts/stm32mp135f-dhcor-dhsbc-u-boot.dtsi b/arch/arm/dts/stm32mp135f-dhcor-dhsbc-u-boot.dtsi
index d718aae..eace94f 100644
--- a/arch/arm/dts/stm32mp135f-dhcor-dhsbc-u-boot.dtsi
+++ b/arch/arm/dts/stm32mp135f-dhcor-dhsbc-u-boot.dtsi
@@ -23,3 +23,25 @@
&usbphyc {
bootph-all;
};
+
+&st33htph {
+ reset-gpios = <&gpioe 12 GPIO_ACTIVE_LOW>;
+};
+
+/* LDO2 is expansion connector 3V3 supply on STM32MP13xx DHCOR DHSBC rev.200 */
+&vdd_ldo2 {
+ bootph-all;
+ regulator-always-on;
+ regulator-boot-on;
+ regulator-min-microvolt = <3300000>;
+ regulator-max-microvolt = <3300000>;
+};
+
+/* LDO5 is carrier board 3V3 supply on STM32MP13xx DHCOR DHSBC rev.200 */
+&vdd_sd {
+ bootph-all;
+ regulator-always-on;
+ regulator-boot-on;
+ regulator-min-microvolt = <3300000>;
+ regulator-max-microvolt = <3300000>;
+};