riscv: qemu: add SPL configuration
Add two new configurations (qemu-riscv{32,64}_spl_defconfig) with SPL
enabled for RISC-V QEMU. QEMU does not require SPL to run U-Boot. The
configurations are meant to help the development of SPL on RISC-V.
The configurations enable RAM as the only SPL boot device. Images must
be loaded at address 0x80200000. In the default boot flow, U-Boot SPL
starts in machine mode, loads the OpenSBI FW_DYNAMIC firmware and U-Boot
proper from the supplied FIT image, and starts OpenSBI. U-Boot proper is
then started in supervisor mode by OpenSBI.
Signed-off-by: Lukas Auer <lukas.auer@aisec.fraunhofer.de>
Reviewed-by: Bin Meng <bmeng.cn@gmail.com>
Tested-by: Bin Meng <bmeng.cn@gmail.com>
Reviewed-by: Anup Patel <anup.patel@wdc.com>
diff --git a/configs/qemu-riscv64_spl_defconfig b/configs/qemu-riscv64_spl_defconfig
new file mode 100644
index 0000000..a3f5e29
--- /dev/null
+++ b/configs/qemu-riscv64_spl_defconfig
@@ -0,0 +1,12 @@
+CONFIG_RISCV=y
+CONFIG_NR_DRAM_BANKS=1
+CONFIG_SPL=y
+CONFIG_TARGET_QEMU_VIRT=y
+CONFIG_ARCH_RV64I=y
+CONFIG_RISCV_SMODE=y
+CONFIG_DISTRO_DEFAULTS=y
+CONFIG_FIT=y
+CONFIG_DISPLAY_CPUINFO=y
+CONFIG_DISPLAY_BOARDINFO=y
+# CONFIG_CMD_MII is not set
+CONFIG_OF_PRIOR_STAGE=y