Restore patch series "arm: dts: am62-beagleplay: Fix Beagleplay Ethernet"
As part of bringing the master branch back in to next, we need to allow
for all of these changes to exist here.
Reported-by: Jonas Karlman <jonas@kwiboo.se>
Signed-off-by: Tom Rini <trini@konsulko.com>
diff --git a/drivers/mmc/Kconfig b/drivers/mmc/Kconfig
index 5496348..d094479 100644
--- a/drivers/mmc/Kconfig
+++ b/drivers/mmc/Kconfig
@@ -147,9 +147,16 @@
support. For eMMC this not mandatory, but not enabling this option may
prevent the driver of using the faster modes.
+config MMC_SUPPORTS_TUNING
+ bool
+
+config SPL_MMC_SUPPORTS_TUNING
+ bool
+
config MMC_UHS_SUPPORT
bool "enable UHS support"
depends on MMC_IO_VOLTAGE
+ select MMC_SUPPORTS_TUNING
help
The Ultra High Speed (UHS) bus is available on some SDHC and SDXC
cards. The IO voltage must be switchable from 3.3v to 1.8v. The bus
@@ -158,6 +165,7 @@
config SPL_MMC_UHS_SUPPORT
bool "enable UHS support in SPL"
depends on SPL_MMC_IO_VOLTAGE
+ select SPL_MMC_SUPPORTS_TUNING
help
The Ultra High Speed (UHS) bus is available on some SDHC and SDXC
cards. The IO voltage must be switchable from 3.3v to 1.8v. The bus
@@ -193,6 +201,7 @@
config MMC_HS200_SUPPORT
bool "enable HS200 support"
+ select MMC_SUPPORTS_TUNING
help
The HS200 mode is support by some eMMC. The bus frequency is up to
200MHz. This mode requires tuning the IO.
@@ -200,6 +209,7 @@
config SPL_MMC_HS200_SUPPORT
bool "enable HS200 support in SPL"
depends on SPL_MMC
+ select SPL_MMC_SUPPORTS_TUNING
help
The HS200 mode is support by some eMMC. The bus frequency is up to
200MHz. This mode requires tuning the IO.
@@ -347,6 +357,7 @@
bool "Marvell Octeon Multimedia Card Interface support"
depends on (ARCH_OCTEON || ARCH_OCTEONTX || ARCH_OCTEONTX2)
depends on DM_MMC
+ select MMC_SUPPORTS_TUNING if ARCH_OCTEONTX2
help
This selects the Octeon Multimedia card Interface.
If you have an OcteonTX/TX2 or MIPS Octeon board with a