ARM: dts: stm32: add SCMI version of STM32 boards (DK1/DK2/ED1/EV1)
Add a "secure" version of STM32 boards based on SCMI when RCC_TZCR.TZEN=1.
Only boards provided by STMicroelectronics are concerned:
-STM32MP157A-DK1
-STM32MP157C-DK2
-STM32MP157C-ED1
-STM32MP157C-EV1
The resources secured by RCC_TZCR.TZEN=1 are managed by OP-TEE
and the associated SCMI services, reset and clock.
These device trees are only supported with stm32mp15_defconfig,
with OP-TEE, SCMI and without SPL support.
Signed-off-by: Patrick Delaunay <patrick.delaunay@foss.st.com>
Reviewed-by: Patrice Chotard <patrice.chotard@foss.st.com>
diff --git a/arch/arm/dts/stm32mp157c-ed1-scmi-u-boot.dtsi b/arch/arm/dts/stm32mp157c-ed1-scmi-u-boot.dtsi
new file mode 100644
index 0000000..54662f7
--- /dev/null
+++ b/arch/arm/dts/stm32mp157c-ed1-scmi-u-boot.dtsi
@@ -0,0 +1,47 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR BSD-3-Clause
+/*
+ * Copyright : STMicroelectronics 2022
+ */
+
+#include <dt-bindings/clock/stm32mp1-clksrc.h>
+#include "stm32mp15-scmi-u-boot.dtsi"
+#include "stm32mp15-ddr3-2x4Gb-1066-binG.dtsi"
+
+/ {
+ aliases {
+ i2c3 = &i2c4;
+ };
+
+ config {
+ u-boot,boot-led = "heartbeat";
+ u-boot,error-led = "error";
+ u-boot,mmc-env-partition = "u-boot-env";
+ st,fastboot-gpios = <&gpioa 13 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>;
+ st,stm32prog-gpios = <&gpioa 14 (GPIO_ACTIVE_LOW | GPIO_PULL_UP)>;
+ };
+
+ led {
+ red {
+ label = "error";
+ gpios = <&gpioa 13 GPIO_ACTIVE_LOW>;
+ default-state = "off";
+ status = "okay";
+ };
+ };
+};
+
+&uart4 {
+ u-boot,dm-pre-reloc;
+};
+
+&uart4_pins_a {
+ u-boot,dm-pre-reloc;
+ pins1 {
+ u-boot,dm-pre-reloc;
+ };
+ pins2 {
+ u-boot,dm-pre-reloc;
+ /* pull-up on rx to avoid floating level */
+ bias-pull-up;
+ };
+};