README: mx28_common: Keep the text within 80 columns
In order to improve readability keep the text within 80 columns.
Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
diff --git a/doc/README.mx28_common b/doc/README.mx28_common
index 8bacaf8..ac82419 100644
--- a/doc/README.mx28_common
+++ b/doc/README.mx28_common
@@ -63,9 +63,9 @@
2) Compiling U-Boot for a MX28 based board
-------------------------------------------
-Compiling the U-Boot for a MX28 board is straightforward and done as compiling U-Boot
-for any other ARM device. For cross-compiler setup, please refer to ELDK5.0
-documentation. First, clean up the source code:
+Compiling the U-Boot for a MX28 board is straightforward and done as compiling
+U-Boot for any other ARM device. For cross-compiler setup, please refer to
+ELDK5.0 documentation. First, clean up the source code:
$ make mrproper
@@ -150,8 +150,8 @@
4) Installation of U-Boot into NAND flash
-----------------------------------------
-To boot a MX28 based board from NAND, set the boot mode DIP switches according to i.MX28
-manual chapter 12.2.1 (Table 12-2), PORT=GPMI, NAND 1.8 V.
+To boot a MX28 based board from NAND, set the boot mode DIP switches according
+to i.MX28 manual chapter 12.2.1 (Table 12-2), PORT=GPMI, NAND 1.8 V.
There are two possibilities when preparing an image writable to NAND flash.