mx7d: Add Storopack's SMEGW01 board
Add support for Storopack's SMEGW01 board, which is an
IoT gateway based on the i.MX7D SoC.
Based on the original U-Boot work done by Phytec.
Signed-off-by: Fabio Estevam <festevam@denx.de>
diff --git a/configs/smegw01_defconfig b/configs/smegw01_defconfig
new file mode 100644
index 0000000..aa10577
--- /dev/null
+++ b/configs/smegw01_defconfig
@@ -0,0 +1,63 @@
+CONFIG_ARM=y
+CONFIG_ARCH_MX7=y
+CONFIG_NR_DRAM_BANKS=1
+CONFIG_SYS_MEMTEST_START=0x80000000
+CONFIG_SYS_MEMTEST_END=0xa0000000
+CONFIG_ENV_SIZE=0x2000
+CONFIG_ENV_OFFSET=0xC0000
+CONFIG_DM_GPIO=y
+CONFIG_TARGET_SMEGW01=y
+CONFIG_ARMV7_BOOT_SEC_DEFAULT=y
+# CONFIG_ARMV7_VIRT is not set
+CONFIG_IMX_RDC=y
+CONFIG_IMX_BOOTAUX=y
+CONFIG_DEFAULT_DEVICE_TREE="imx7d-smegw01"
+CONFIG_FIT=y
+CONFIG_FIT_VERBOSE=y
+CONFIG_SYS_EXTRA_OPTIONS="IMX_CONFIG=board/storopack/smegw01/imximage.cfg"
+CONFIG_HUSH_PARSER=y
+# CONFIG_CMD_BOOTD is not set
+CONFIG_CMD_BOOTZ=y
+# CONFIG_CMD_IMI is not set
+# CONFIG_CMD_XIMG is not set
+CONFIG_CMD_MEMTEST=y
+CONFIG_CMD_DFU=y
+CONFIG_CMD_GPIO=y
+CONFIG_CMD_MMC=y
+CONFIG_CMD_PART=y
+CONFIG_CMD_DHCP=y
+CONFIG_CMD_CACHE=y
+CONFIG_CMD_EXT2=y
+CONFIG_CMD_EXT4=y
+CONFIG_CMD_EXT4_WRITE=y
+CONFIG_CMD_FAT=y
+CONFIG_CMD_FS_GENERIC=y
+CONFIG_OF_CONTROL=y
+CONFIG_ENV_OVERWRITE=y
+CONFIG_SYS_RELOC_GD_ENV_ADDR=y
+CONFIG_NET_RANDOM_ETHADDR=y
+CONFIG_BOUNCE_BUFFER=y
+CONFIG_DFU_MMC=y
+CONFIG_DM_I2C=y
+CONFIG_SUPPORT_EMMC_BOOT=y
+CONFIG_FSL_USDHC=y
+CONFIG_MTD=y
+CONFIG_PHYLIB=y
+CONFIG_PHY_MICREL=y
+CONFIG_PHY_MICREL_KSZ90X1=y
+CONFIG_DM_ETH=y
+CONFIG_FEC_MXC=y
+CONFIG_RGMII=y
+CONFIG_MII=y
+CONFIG_PINCTRL=y
+CONFIG_PINCTRL_IMX7=y
+CONFIG_DM_PMIC=y
+CONFIG_DM_PMIC_PFUZE100=y
+CONFIG_DM_REGULATOR=y
+CONFIG_DM_REGULATOR_PFUZE100=y
+CONFIG_DM_REGULATOR_FIXED=y
+CONFIG_DM_REGULATOR_GPIO=y
+CONFIG_SPECIFY_CONSOLE_INDEX=y
+CONFIG_DM_SERIAL=y
+CONFIG_MXC_UART=y
+CONFIG_IMX_THERMAL=y