rockchip: rk3328: Fix loading FIT from SD-card when booting from eMMC
When RK3328 boards run SPL from eMMC and fail to load FIT from eMMC due
to it being missing or checksum validation fails there is a fallback to
read FIT from SD-card. However, without proper pinctrl configuration
reading FIT from SD-card will fail:
U-Boot SPL 2024.04-rc1 (Feb 05 2024 - 22:18:22 +0000)
Trying to boot from MMC1
mmc_load_image_raw_sector: mmc block read error
Trying to boot from MMC2
Card did not respond to voltage select! : -110
spl: mmc init failed with error: -95
Trying to boot from MMC1
mmc_load_image_raw_sector: mmc block read error
SPL: failed to boot from all boot devices
### ERROR ### Please RESET the board ###
Fix this by tagging related emmc and sdmmc pinctrl nodes with bootph
props. Also sort and move common nodes shared by all boards to the SoC
u-boot.dtsi.
Signed-off-by: Jonas Karlman <jonas@kwiboo.se>
Reviewed-by: Kever Yang <kever.yang@rock-chips.com>
diff --git a/arch/arm/dts/rk3328-orangepi-r1-plus-u-boot.dtsi b/arch/arm/dts/rk3328-orangepi-r1-plus-u-boot.dtsi
index 2e3b6a7..35baeb2 100644
--- a/arch/arm/dts/rk3328-orangepi-r1-plus-u-boot.dtsi
+++ b/arch/arm/dts/rk3328-orangepi-r1-plus-u-boot.dtsi
@@ -7,29 +7,16 @@
#include "rk3328-u-boot.dtsi"
#include "rk3328-sdram-ddr4-666.dtsi"
-&gpio0 {
- bootph-pre-ram;
-};
-
-&pinctrl {
- bootph-pre-ram;
-};
-
-&sdmmc0m1_pin {
+&spi0 {
bootph-pre-ram;
-};
+ bootph-some-ram;
-&pcfg_pull_up_4ma {
- bootph-pre-ram;
+ flash@0 {
+ bootph-pre-ram;
+ bootph-some-ram;
+ };
};
-/* Need this and all the pinctrl/gpio stuff above to set pinmux */
&vcc_sd {
bootph-pre-ram;
};
-
-&spi0 {
- spi_flash: spiflash@0 {
- bootph-all;
- };
-};