Merge with git://www.denx.de/git/u-boot.git
diff --git a/board/amcc/luan/luan.c b/board/amcc/luan/luan.c
index 7b16f8a..0067ce0 100644
--- a/board/amcc/luan/luan.c
+++ b/board/amcc/luan/luan.c
@@ -39,8 +39,6 @@
************************************************************************/
int board_early_init_f(void)
{
- volatile epld_t *x = (epld_t *) CFG_EPLD_BASE;
-
mtebc( pb0ap, 0x03800000 ); /* set chip selects */
mtebc( pb0cr, 0xffc58000 ); /* ebc0_b0cr, 4MB at 0xffc00000 CS0 */
mtebc( pb1ap, 0x03800000 );
@@ -66,8 +64,6 @@
mtdcr( uic0sr, 0x00000000 ); /* clear all interrupts */
mtdcr( uic0sr, 0xffffffff );
- x->ethuart &= ~EPLD2_RESET_ETH_N; /* put Ethernet+PHY in reset */
-
return 0;
}
@@ -79,7 +75,18 @@
int misc_init_r(void)
{
volatile epld_t *x = (epld_t *) CFG_EPLD_BASE;
- x->ethuart |= EPLD2_RESET_ETH_N; /* take Ethernet+PHY out of reset */
+
+ /* set modes of operation */
+ x->ethuart |= EPLD2_ETH_MODE_10 | EPLD2_ETH_MODE_100 |
+ EPLD2_ETH_MODE_1000 | EPLD2_ETH_DUPLEX_MODE;
+ /* clear ETHERNET_AUTO_NEGO bit to turn on autonegotiation */
+ x->ethuart &= ~EPLD2_ETH_AUTO_NEGO;
+
+ /* put Ethernet+PHY in reset */
+ x->ethuart &= ~EPLD2_RESET_ETH_N;
+ udelay(10000);
+ /* take Ethernet+PHY out of reset */
+ x->ethuart |= EPLD2_RESET_ETH_N;
return 0;
}
diff --git a/cpu/ppc4xx/440spe_pcie.c b/cpu/ppc4xx/440spe_pcie.c
index 158f1c5..3eac0ae 100644
--- a/cpu/ppc4xx/440spe_pcie.c
+++ b/cpu/ppc4xx/440spe_pcie.c
@@ -104,7 +104,7 @@
if ((!((PCI_FUNC(devfn) == 0) && (PCI_DEV(devfn) == 0))) &&
((PCI_BUS(devfn) == 0) || (PCI_BUS(devfn) == 1)))
return 0;
-
+
address = pcie_get_base(hose, devfn);
offset += devfn << 4;
@@ -136,12 +136,12 @@
int offset, int len, u32 val) {
u8 *address;
-
+
/*
* Bus numbers are relative to hose->first_busno
*/
devfn -= PCI_BDF(hose->first_busno, 0, 0);
-
+
/*
* Same constraints as in pcie_read_config().
*/
@@ -151,7 +151,7 @@
if ((!((PCI_FUNC(devfn) == 0) && (PCI_DEV(devfn) == 0))) &&
((PCI_BUS(devfn) == 0) || (PCI_BUS(devfn) == 1)))
return 0;
-
+
address = pcie_get_base(hose, devfn);
offset += devfn << 4;
@@ -926,7 +926,7 @@
in_le16((u16 *)(mbase + PCI_COMMAND)) |
PCI_COMMAND_IO | PCI_COMMAND_MEMORY | PCI_COMMAND_MASTER);
printf("PCIE:%d successfully set as rootpoint\n",port);
-
+
/* Set Device and Vendor Id */
switch (port) {
case 0:
diff --git a/cpu/ppc4xx/4xx_enet.c b/cpu/ppc4xx/4xx_enet.c
index cc8e734..71a9e37 100644
--- a/cpu/ppc4xx/4xx_enet.c
+++ b/cpu/ppc4xx/4xx_enet.c
@@ -138,7 +138,8 @@
#define BI_PHYMODE_MII 7
#endif
-#if defined(CONFIG_440SPE) || defined(CONFIG_440EPX) || defined(CONFIG_440GRX)
+#if defined(CONFIG_440SPE) || defined(CONFIG_440EPX) || \
+ defined(CONFIG_440GRX) || defined(CONFIG_440SP)
#define SDR0_MFR_ETH_CLK_SEL_V(n) ((0x01<<27) / (n+1))
#endif
@@ -408,7 +409,8 @@
int ethgroup = -1;
#endif
#endif
-#if defined(CONFIG_440EPX) || defined(CONFIG_440GRX) || defined(CONFIG_440SPE)
+#if defined(CONFIG_440EPX) || defined(CONFIG_440GRX) || \
+ defined(CONFIG_440SP) || defined(CONFIG_440SPE)
unsigned long mfr;
#endif
@@ -500,7 +502,8 @@
__asm__ volatile ("eieio");
/* reset emac so we have access to the phy */
-#if defined(CONFIG_440SPE) || defined(CONFIG_440EPX) || defined(CONFIG_440GRX)
+#if defined(CONFIG_440EPX) || defined(CONFIG_440GRX) || \
+ defined(CONFIG_440SP) || defined(CONFIG_440SPE)
/* provide clocks for EMAC internal loopback */
mfsdr (sdr_mfr, mfr);
mfr |= SDR0_MFR_ETH_CLK_SEL_V(devnum);
@@ -518,7 +521,8 @@
if (failsafe <= 0)
printf("\nProblem resetting EMAC!\n");
-#if defined(CONFIG_440SPE) || defined(CONFIG_440EPX) || defined(CONFIG_440GRX)
+#if defined(CONFIG_440EPX) || defined(CONFIG_440GRX) || \
+ defined(CONFIG_440SP) || defined(CONFIG_440SPE)
/* remove clocks for EMAC internal loopback */
mfsdr (sdr_mfr, mfr);
mfr &= ~SDR0_MFR_ETH_CLK_SEL_V(devnum);
@@ -920,8 +924,8 @@
/* set speed */
if (speed == _1000BASET) {
-#if defined(CONFIG_440SP) || defined(CONFIG_440SPE) || \
- defined(CONFIG_440EPX) || defined(CONFIG_440GRX)
+#if defined(CONFIG_440EPX) || defined(CONFIG_440GRX) || \
+ defined(CONFIG_440SP) || defined(CONFIG_440SPE)
unsigned long pfc1;
mfsdr (sdr_pfc1, pfc1);
diff --git a/include/configs/lwmon5.h b/include/configs/lwmon5.h
index be48324..00c34d5d 100644
--- a/include/configs/lwmon5.h
+++ b/include/configs/lwmon5.h
@@ -200,12 +200,13 @@
"ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}" \
":${hostname}:${netdev}:off panic=1\0" \
"addtty=setenv bootargs ${bootargs} console=ttyS1,${baudrate}\0"\
- "flash_nfs=run nfsargs addip addtty;" \
+ "addmisc=setenv bootargs ${bootargs} rtc-pcf8563.probe=0,0x51\0"\
+ "flash_nfs=run nfsargs addip addtty addmisc;" \
"bootm ${kernel_addr}\0" \
- "flash_self=run ramargs addip addtty;" \
+ "flash_self=run ramargs addip addtty addmisc;" \
"bootm ${kernel_addr} ${ramdisk_addr}\0" \
- "net_nfs=tftp 200000 ${bootfile};run nfsargs addip addtty;" \
- "bootm\0" \
+ "net_nfs=tftp 200000 ${bootfile};" \
+ "run nfsargs addip addtty addmisc;bootm\0" \
"rootpath=/opt/eldk/ppc_4xxFP\0" \
"bootfile=/tftpboot/lwmon5/uImage\0" \
"kernel_addr=FC000000\0" \
@@ -338,7 +339,12 @@
#define CFG_PCI_SUBSYS_VENDORID 0x10e8 /* AMCC */
#define CFG_PCI_SUBSYS_ID 0xcafe /* Whatever */
+#if 0
+/*
+ * ToDo: Watchdog is not test fully, so exclude it for now
+ */
#define CONFIG_HW_WATCHDOG 1 /* Use external HW-Watchdog */
+#endif
/*
* For booting Linux, the board info and command line data
@@ -472,7 +478,7 @@
{GPIO1_BASE, GPIO_OUT, GPIO_SEL , GPIO_OUT_1}, /* GPIO55 Unselect via TraceSelect Bit */ \
{GPIO1_BASE, GPIO_OUT, GPIO_SEL , GPIO_OUT_0}, /* GPIO56 Unselect via TraceSelect Bit */ \
{GPIO1_BASE, GPIO_OUT, GPIO_SEL , GPIO_OUT_1}, /* GPIO57 Unselect via TraceSelect Bit */ \
-{GPIO1_BASE, GPIO_OUT, GPIO_SEL , GPIO_OUT_1}, /* GPIO58 Unselect via TraceSelect Bit */ \
+{GPIO1_BASE, GPIO_OUT, GPIO_SEL , GPIO_OUT_0}, /* GPIO58 Unselect via TraceSelect Bit */ \
{GPIO1_BASE, GPIO_OUT, GPIO_SEL , GPIO_OUT_0}, /* GPIO59 Unselect via TraceSelect Bit */ \
{GPIO1_BASE, GPIO_OUT, GPIO_SEL , GPIO_OUT_0}, /* GPIO60 Unselect via TraceSelect Bit */ \
{GPIO1_BASE, GPIO_IN , GPIO_SEL , GPIO_OUT_0}, /* GPIO61 Unselect via TraceSelect Bit */ \