board: phytec: phycore-am62x: Use memory nodes in higher boot stages
There is no need to reread the EEPROM multiple times in different stages
to detect the RAM size. We can do this once at an early stage and let
higher stages decode memory nodes using fdtdec.
Make sure to pass fixup memory nodes before passing to u-boot stage.
Signed-off-by: Wadim Egorov <w.egorov@phytec.de>
Reviewed-by: Daniel Schultz <d.schultz@phytec.de>
diff --git a/board/phytec/phycore_am62x/phycore-am62x.c b/board/phytec/phycore_am62x/phycore-am62x.c
index 35e1bb9..9f6bc73 100644
--- a/board/phytec/phycore_am62x/phycore-am62x.c
+++ b/board/phytec/phycore_am62x/phycore-am62x.c
@@ -47,7 +47,12 @@
int dram_init(void)
{
- u8 ram_size = phytec_get_am62_ddr_size_default();
+ u8 ram_size;
+
+ if (!IS_ENABLED(CONFIG_CPU_V7R))
+ return fdtdec_setup_mem_size_base();
+
+ ram_size = phytec_get_am62_ddr_size_default();
/*
* HACK: ddrss driver support 2GB RAM by default
@@ -92,6 +97,9 @@
{
u8 ram_size;
+ if (!IS_ENABLED(CONFIG_CPU_V7R))
+ return fdtdec_setup_memory_banksize();
+
ram_size = phytec_get_am62_ddr_size_default();
switch (ram_size) {
case EEPROM_RAM_SIZE_1GB:
@@ -174,6 +182,26 @@
}
#endif
+#if IS_ENABLED(CONFIG_SPL_BUILD)
+void spl_perform_fixups(struct spl_image_info *spl_image)
+{
+ u64 start[CONFIG_NR_DRAM_BANKS];
+ u64 size[CONFIG_NR_DRAM_BANKS];
+ int bank;
+ int ret;
+
+ dram_init();
+ dram_init_banksize();
+
+ for (bank = 0; bank < CONFIG_NR_DRAM_BANKS; bank++) {
+ start[bank] = gd->bd->bi_dram[bank].start;
+ size[bank] = gd->bd->bi_dram[bank].size;
+ }
+
+ ret = fdt_fixup_memory_banks(spl_image->fdt_addr, start, size, CONFIG_NR_DRAM_BANKS);
+}
+#endif
+
#define CTRLMMR_USB0_PHY_CTRL 0x43004008
#define CTRLMMR_USB1_PHY_CTRL 0x43004018
#define CORE_VOLTAGE 0x80000000