dm: power: Allow regulators to be omitted from SPL
For some boards the pmic interface is useful but the regulator interface
(which comes with it) is too large. Allow them to be separated such that
SPL can decide which it needs.
Signed-off-by: Simon Glass <sjg@chromium.org>
diff --git a/drivers/power/pmic/Kconfig b/drivers/power/pmic/Kconfig
index 8be3c07..7f69ae1 100644
--- a/drivers/power/pmic/Kconfig
+++ b/drivers/power/pmic/Kconfig
@@ -10,6 +10,27 @@
- 'drivers/power/pmic/pmic-uclass.c'
- 'include/power/pmic.h'
+config PMIC_CHILDREN
+ bool "Allow child devices for PMICs"
+ depends on DM_PMIC
+ default y
+ ---help---
+ This allows PMICs to support child devices (such as regulators) in
+ SPL. This adds quite a bit of code so if you are not using this
+ feature you can turn it off. Most likely you should turn it on for
+ U-Boot proper.
+
+config SPL_PMIC_CHILDREN
+ bool "Allow child devices for PMICs in SPL"
+ depends on DM_PMIC
+ default y
+ ---help---
+ This allows PMICs to support child devices (such as regulators) in
+ SPL. This adds quite a bit of code so if you are not using this
+ feature you can turn it off. In this case you may need a 'back door'
+ to call your regulator code (e.g. see rk808.c for direct functions
+ for use in SPL).
+
config PMIC_ACT8846
bool "Enable support for the active-semi 8846 PMIC"
depends on DM_PMIC && DM_I2C