mips: ocelot: Enable use of serial gpio for LED
This enables the use of the MSCC serial GPIO driver to control the
LEDs on the MSCC VCoreIII 'ocelot' pcb123 and pcb120.
Signed-off-by: Lars Povlsen <lars.povlsen@microchip.com>
diff --git a/board/mscc/ocelot/ocelot.c b/board/mscc/ocelot/ocelot.c
index a557cac..a05c308 100644
--- a/board/mscc/ocelot/ocelot.c
+++ b/board/mscc/ocelot/ocelot.c
@@ -9,6 +9,7 @@
#include <asm/types.h>
#include <environment.h>
#include <spi.h>
+#include <led.h>
DECLARE_GLOBAL_DATA_PTR;
@@ -56,6 +57,11 @@
/* Address of boot parameters */
gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE;
+
+ /* LED setup */
+ if (IS_ENABLED(CONFIG_LED))
+ led_default_state();
+
return 0;
}
diff --git a/configs/mscc_ocelot_defconfig b/configs/mscc_ocelot_defconfig
index 6645100..fb6a5bd 100644
--- a/configs/mscc_ocelot_defconfig
+++ b/configs/mscc_ocelot_defconfig
@@ -48,6 +48,9 @@
CONFIG_DM_GPIO=y
CONFIG_MTD=y
CONFIG_MTD_SPI_NAND=y
+CONFIG_MSCC_SGPIO=y
+CONFIG_LED=y
+CONFIG_LED_GPIO=y
CONFIG_DM_SPI_FLASH=y
CONFIG_SPI_FLASH=y
CONFIG_SPI_FLASH_BAR=y