ARMv8/ls2085a_emu: Enable DP-DDR as standalone memory block
DP-DDR is used for DPAA, separated from main memory pool for general
use. It has 32-bit bus width and use a standard DDR4 DIMM (64-bit).
Signed-off-by: York Sun <yorksun@freescale.com>
diff --git a/board/freescale/ls2085a/ddr.c b/board/freescale/ls2085a/ddr.c
index 257bc16..b4a3fc9 100644
--- a/board/freescale/ls2085a/ddr.c
+++ b/board/freescale/ls2085a/ddr.c
@@ -30,9 +30,9 @@
* to pbsp = rdimms[ctrl_num] or pbsp = udimms[ctrl_num];
*/
if (popts->registered_dimm_en)
- pbsp = rdimms[0];
+ pbsp = rdimms[ctrl_num];
else
- pbsp = udimms[0];
+ pbsp = udimms[ctrl_num];
/* Get clk_adjust, wrlvl_start, wrlvl_ctl, according to the board ddr
@@ -72,6 +72,12 @@
pbsp->clk_adjust, pbsp->wrlvl_start, pbsp->wrlvl_ctl_2,
pbsp->wrlvl_ctl_3);
+ if (ctrl_num == CONFIG_DP_DDR_CTRL) {
+ /* force DDR bus width to 32 bits */
+ popts->data_bus_width = 1;
+ popts->otf_burst_chop_en = 0;
+ popts->burst_length = DDR_BL8;
+ }
/*
* Factors to consider for half-strength driver enable:
* - number of DIMMs installed
@@ -163,6 +169,10 @@
void dram_init_banksize(void)
{
+#ifdef CONFIG_SYS_DP_DDR_BASE_PHY
+ phys_size_t dp_ddr_size;
+#endif
+
gd->bd->bi_dram[0].start = CONFIG_SYS_SDRAM_BASE;
if (gd->ram_size > CONFIG_SYS_LS2_DDR_BLOCK1_SIZE) {
gd->bd->bi_dram[0].size = CONFIG_SYS_LS2_DDR_BLOCK1_SIZE;
@@ -172,4 +182,24 @@
} else {
gd->bd->bi_dram[0].size = gd->ram_size;
}
+
+#ifdef CONFIG_SYS_DP_DDR_BASE_PHY
+ /* initialize DP-DDR here */
+ puts("DP-DDR: ");
+ /*
+ * DDR controller use 0 as the base address for binding.
+ * It is mapped to CONFIG_SYS_DP_DDR_BASE for core to access.
+ */
+ dp_ddr_size = fsl_other_ddr_sdram(CONFIG_SYS_DP_DDR_BASE_PHY,
+ CONFIG_DP_DDR_CTRL,
+ CONFIG_DP_DDR_NUM_CTRLS,
+ CONFIG_DP_DDR_DIMM_SLOTS_PER_CTLR,
+ NULL, NULL, NULL);
+ if (dp_ddr_size) {
+ gd->bd->bi_dram[2].start = CONFIG_SYS_DP_DDR_BASE;
+ gd->bd->bi_dram[2].size = dp_ddr_size;
+ } else {
+ puts("Not detected");
+ }
+#endif
}