engicam: common: Move common board code
Move possible common board code into common area
from supported boards.
Cc: Stefano Babic <sbabic@denx.de>
Cc: Matteo Lisi <matteo.lisi@engicam.com>
Cc: Michael Trimarchi <michael@amarulasolutions.com>
Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>
diff --git a/board/engicam/geam6ul/geam6ul.c b/board/engicam/geam6ul/geam6ul.c
index 408b476..c992035 100644
--- a/board/engicam/geam6ul/geam6ul.c
+++ b/board/engicam/geam6ul/geam6ul.c
@@ -20,6 +20,8 @@
#include <asm/arch/sys_proto.h>
#include <asm/imx-common/iomux-v3.h>
+#include "../common/board.h"
+
DECLARE_GLOBAL_DATA_PTR;
#ifdef CONFIG_NAND_MXS
@@ -47,7 +49,7 @@
IOMUX_PADS(PAD_NAND_READY_B__RAWNAND_READY_B | MUX_PAD_CTRL(GPMI_PAD_CTRL2)),
};
-static void setup_gpmi_nand(void)
+void setup_gpmi_nand(void)
{
struct mxc_ccm_reg *mxc_ccm = (struct mxc_ccm_reg *)CCM_BASE_ADDR;
@@ -88,24 +90,6 @@
}
#endif /* CONFIG_NAND_MXS */
-#ifdef CONFIG_ENV_IS_IN_MMC
-static void mmc_late_init(void)
-{
- char cmd[32];
- char mmcblk[32];
- u32 dev_no = mmc_get_env_dev();
-
- setenv_ulong("mmcdev", dev_no);
-
- /* Set mmcblk env */
- sprintf(mmcblk, "/dev/mmcblk%dp2 rootwait rw", dev_no);
- setenv("mmcroot", mmcblk);
-
- sprintf(cmd, "mmc dev %d", dev_no);
- run_command(cmd, 0);
-}
-#endif
-
int board_late_init(void)
{
switch ((imx6_src_get_boot_mode() & IMX6_BMODE_MASK) >>
@@ -131,25 +115,6 @@
return 0;
}
-int board_init(void)
-{
- /* Address of boot parameters */
- gd->bd->bi_boot_params = PHYS_SDRAM + 0x100;
-
-#ifdef CONFIG_NAND_MXS
- setup_gpmi_nand();
-#endif
-
- return 0;
-}
-
-int dram_init(void)
-{
- gd->ram_size = imx_ddr_size();
-
- return 0;
-}
-
#ifdef CONFIG_SPL_BUILD
/* MMC board initialization is needed till adding DM support in SPL */
#if defined(CONFIG_FSL_ESDHC) && !defined(CONFIG_DM_MMC)