General help message cleanup
Many of the help messages were not really helpful; for example, many
commands that take no arguments would not print a correct synopsis
line, but "No additional help available." which is not exactly wrong,
but not helpful either.
Commit ``Make "usage" messages more helpful.'' changed this
partially. But it also became clear that lots of "Usage" and "Help"
messages (fields "usage" and "help" in struct cmd_tbl_s respective)
were actually redundant.
This patch cleans this up - for example:
Before:
=> help dtt
dtt - Digital Thermometer and Thermostat
Usage:
dtt - Read temperature from digital thermometer and thermostat.
After:
=> help dtt
dtt - Read temperature from Digital Thermometer and Thermostat
Usage:
dtt
Signed-off-by: Wolfgang Denk <wd@denx.de>
diff --git a/board/trab/cmd_trab.c b/board/trab/cmd_trab.c
index 7e2a672..d0465fb 100644
--- a/board/trab/cmd_trab.c
+++ b/board/trab/cmd_trab.c
@@ -262,7 +262,7 @@
"\n"
" - start burn-in test application\n"
" The burn-in test could took a while to finish!\n"
- " The content of the onboard EEPROM is modified!\n"
+ " The content of the onboard EEPROM is modified!"
);
@@ -295,7 +295,7 @@
"read dip switch on TRAB",
"\n"
" - read state of dip switch (S1) on TRAB board\n"
- " read sequence: 1-2-3-4; ON=1; OFF=0; e.g.: \"0100\"\n"
+ " read sequence: 1-2-3-4; ON=1; OFF=0; e.g.: \"0100\""
);
@@ -323,7 +323,7 @@
vcc5v, 1, 1, do_vcc5v,
"read VCC5V on TRAB",
"\n"
- " - read actual value of voltage VCC5V\n"
+ " - read actual value of voltage VCC5V"
);
@@ -347,7 +347,7 @@
U_BOOT_CMD(
c_temp, 1, 1, do_contact_temp,
"read contact temperature on TRAB",
- "\n"
+ ""
" - reads the onboard temperature (=contact temperature)\n"
);
@@ -401,7 +401,7 @@
"print burn in status on TRAB",
"\n"
" - prints the status variables of the last burn in test\n"
- " stored in the onboard EEPROM on TRAB board\n"
+ " stored in the onboard EEPROM on TRAB board"
);
static int read_dip (void)
@@ -890,7 +890,7 @@
"delay\n"
" - contact temperature [1/100 C] is printed endlessly to console\n"
" <delay> specifies the seconds to wait between two measurements\n"
- " For each measurment a timestamp is printeted\n"
+ " For each measurment a timestamp is printeted"
);
#endif