spl: sandbox: initialise the ram banksize in spl
Initialise the ram bank information for sandbox in SPL. The ram bank
information gets initialised as part of the SPL initialisation
sequence in board_init_r(), which is then used for adding available
memory to the LMB memory map.
Signed-off-by: Sughosh Ganu <sughosh.ganu@linaro.org>
Reviewed-by: Simon Glass <sjg@chromium.org>
diff --git a/arch/sandbox/cpu/spl.c b/arch/sandbox/cpu/spl.c
index cc46965..1c33a52 100644
--- a/arch/sandbox/cpu/spl.c
+++ b/arch/sandbox/cpu/spl.c
@@ -127,6 +127,15 @@
}
SPL_LOAD_IMAGE_METHOD("sandbox_image", 7, BOOT_DEVICE_BOARD, load_from_image);
+int dram_init_banksize(void)
+{
+ /* These are necessary so TFTP can use LMBs to check its load address */
+ gd->bd->bi_dram[0].start = gd->ram_base;
+ gd->bd->bi_dram[0].size = get_effective_memsize();
+
+ return 0;
+}
+
void spl_board_init(void)
{
struct sandbox_state *state = state_get_current();
@@ -134,10 +143,6 @@
if (!CONFIG_IS_ENABLED(UNIT_TEST))
return;
- /* These are necessary so TFTP can use LMBs to check its load address */
- gd->bd->bi_dram[0].start = gd->ram_base;
- gd->bd->bi_dram[0].size = get_effective_memsize();
-
if (state->run_unittests) {
struct unit_test *tests = UNIT_TEST_ALL_START();
const int count = UNIT_TEST_ALL_COUNT();