mx51evk: Use GPIO API for configuring the IOMUX
GPIO API provides mxc_request_iomux function for setting the IOMUX mode.
Use this function instead of directly writing to the IOMUX register.
Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
diff --git a/board/freescale/mx51evk/mx51evk.c b/board/freescale/mx51evk/mx51evk.c
index 2a0dad0..afb1c30 100644
--- a/board/freescale/mx51evk/mx51evk.c
+++ b/board/freescale/mx51evk/mx51evk.c
@@ -254,16 +254,14 @@
pmic_reg_write(p, REG_MODE_1, val);
udelay(200);
- gpio_direction_output(46, 0);
-
- /* Reset the ethernet controller over GPIO */
- writel(0x1, IOMUXC_BASE_ADDR + 0x0AC);
-
/* Enable VGEN3, VCAM, VAUDIO, VVIDEO, VSD regulators */
val = VGEN3EN | VGEN3CONFIG | VCAMEN | VCAMCONFIG |
VVIDEOEN | VAUDIOEN | VSDEN;
pmic_reg_write(p, REG_MODE_1, val);
+ mxc_request_iomux(MX51_PIN_EIM_A20, IOMUX_CONFIG_ALT1);
+ gpio_direction_output(46, 0);
+
udelay(500);
gpio_set_value(46, 1);