usb: dwc3: add Amlogic GXL & GXL DWC3 Glue
The USB support was initialy done with a set of PHYs and dwc3-of-simple
because the architecture of the USB complex was not understood correctly
at the time (and proper documentation was missing...).
But with the G12A family, the USB complex was correctly understood and
implemented correctly.
This adds a proper driver for the glue, based on the G12A one, but with
enough changes to require a different driver in U-Boot.
Signed-off-by: Neil Armstrong <narmstrong@baylibre.com>
diff --git a/drivers/usb/dwc3/Kconfig b/drivers/usb/dwc3/Kconfig
index c302486..802ee50 100644
--- a/drivers/usb/dwc3/Kconfig
+++ b/drivers/usb/dwc3/Kconfig
@@ -38,6 +38,14 @@
Select this for Amlogic Meson G12A Platforms.
This wrapper supports Host and Peripheral operation modes.
+config USB_DWC3_MESON_GXL
+ bool "Amlogic Meson GXL USB wrapper"
+ depends on DM_USB && USB_DWC3 && ARCH_MESON
+ imply PHY
+ help
+ Select this for Amlogic Meson GXL and GXM Platforms.
+ This wrapper supports Host and Peripheral operation modes.
+
config USB_DWC3_UNIPHIER
bool "DesignWare USB3 Host Support on UniPhier Platforms"
depends on ARCH_UNIPHIER && USB_XHCI_DWC3