ARM: mx6: Add function to set serial#
The serial number OTP is similar to the imx7 version, except that the
register names are different. This also sets serial# directly, instead of
providing board_get_serial.
Signed-off-by: Sean Anderson <sean.anderson@seco.com>
Reviewed-by: Tom Rini <trini@konsulko.com>
diff --git a/arch/arm/mach-imx/mx6/soc.c b/arch/arm/mach-imx/mx6/soc.c
index bf6dddf..aacfc85 100644
--- a/arch/arm/mach-imx/mx6/soc.c
+++ b/arch/arm/mach-imx/mx6/soc.c
@@ -7,6 +7,7 @@
*/
#include <common.h>
+#include <env.h>
#include <init.h>
#include <linux/delay.h>
#include <linux/errno.h>
@@ -696,11 +697,47 @@
#endif
#ifdef CONFIG_ARCH_MISC_INIT
+/*
+ * UNIQUE_ID describes a unique ID based on silicon wafer
+ * and die X/Y position
+ *
+ * UNIQUE_ID offset 0x410
+ * 31:0 fuse 0
+ * FSL-wide unique, encoded LOT ID STD II/SJC CHALLENGE/ Unique ID
+ *
+ * UNIQUE_ID offset 0x420
+ * 31:24 fuse 1
+ * The X-coordinate of the die location on the wafer/SJC CHALLENGE/ Unique ID
+ * 23:16 fuse 1
+ * The Y-coordinate of the die location on the wafer/SJC CHALLENGE/ Unique ID
+ * 15:11 fuse 1
+ * The wafer number of the wafer on which the device was fabricated/SJC
+ * CHALLENGE/ Unique ID
+ * 10:0 fuse 1
+ * FSL-wide unique, encoded LOT ID STD II/SJC CHALLENGE/ Unique ID
+ */
+static void setup_serial_number(void)
+{
+ char serial_string[17];
+ struct ocotp_regs *ocotp = (struct ocotp_regs *)OCOTP_BASE_ADDR;
+ struct fuse_bank *bank = &ocotp->bank[0];
+ struct fuse_bank0_regs *fuse =
+ (struct fuse_bank0_regs *)bank->fuse_regs;
+
+ if (env_get("serial#"))
+ return;
+
+ snprintf(serial_string, sizeof(serial_string), "%08x%08x",
+ fuse->uid_low, fuse->uid_high);
+ env_set("serial#", serial_string);
+}
+
int arch_misc_init(void)
{
#ifdef CONFIG_FSL_CAAM
sec_init();
#endif
+ setup_serial_number();
return 0;
}
#endif