diff --git a/arch/arm/include/asm/arch-mx6/sys_proto.h b/arch/arm/include/asm/arch-mx6/sys_proto.h
index c7542e4..7845fa8 100644
--- a/arch/arm/include/asm/arch-mx6/sys_proto.h
+++ b/arch/arm/include/asm/arch-mx6/sys_proto.h
@@ -18,9 +18,6 @@
 #define is_usbotg_phy_active(void) (!(readl(USB_PHY0_BASE_ADDR + USBPHY_PWD) & \
 				   USBPHY_PWD_RXPWDRX))
 
-int imx6_pcie_toggle_power(struct udevice *vpcie);
-int imx6_pcie_toggle_reset(struct gpio_desc *gpio, bool active_high);
-
 enum ldo_reg {
 	LDO_ARM,
 	LDO_SOC,
diff --git a/drivers/pci/pcie_imx.c b/drivers/pci/pcie_imx.c
index f8daedb..46ac017 100644
--- a/drivers/pci/pcie_imx.c
+++ b/drivers/pci/pcie_imx.c
@@ -532,7 +532,7 @@
 	return 0;
 }
 
-__weak int imx6_pcie_toggle_power(struct udevice *vpcie)
+int imx6_pcie_toggle_power(struct udevice *vpcie)
 {
 #ifdef CONFIG_PCIE_IMX_POWER_GPIO
 	gpio_request(CONFIG_PCIE_IMX_POWER_GPIO, "pcie_power");
@@ -554,7 +554,7 @@
 	return 0;
 }
 
-__weak int imx6_pcie_toggle_reset(struct gpio_desc *gpio, bool active_high)
+int imx6_pcie_toggle_reset(struct gpio_desc *gpio, bool active_high)
 {
 	/*
 	 * See 'PCI EXPRESS BASE SPECIFICATION, REV 3.0, SECTION 6.6.1'
@@ -570,12 +570,6 @@
 	 * configuration file and the condition below will handle the rest
 	 * of the reset toggling.
 	 *
-	 * In case your #PERST toggling logic is more complex, for example
-	 * connected via CPLD or somesuch, you can override this function
-	 * in your board file and implement reset logic as needed. You must
-	 * not forget to wait at least 20 ms after de-asserting #PERST in
-	 * this case either though.
-	 *
 	 * In case your #PERST line of the PCIe EP device is not connected
 	 * at all, your design is broken and you should fix your design,
 	 * otherwise you will observe problems like for example the link