SMDK5250: Initialise and Enable DWMMC, support FDT and non-FDT
This patch enables and initialises DWMMC for SMDK5250.
Supports both FDT and non-FDT. This patch creates a new file
'exynos5-dt.c' meant for FDT support.
exynos5-dt.c: This file shall contain all code which supports FDT.
Any addition of FDT support for any module needs to be
added in this file.
smdk5250.c: This file shall contain the code which supports non-FDT.
version. Any addition of non-FDT support for any module
needs to be added in this file.
May be, the file smdk5250.c can be removed in near future
when non-FDT is not required.
The Makefile is updated to compile only one of the files
exynos5-dt.c / smdk5250.c based on FDT configuration.
NOTE:
Please note that all additions corresponding to FDT need to be added into the
file exynos5-dt.c.
At same time if non-FDT support is required then add the corresponding
updations into smdk5250.c.
Signed-off-by: Amar <amarendra.xt@samsung.com>
Signed-off-by: Minkyu Kang <mk7.kang@samsung.com>
diff --git a/drivers/video/exynos_fb.c b/drivers/video/exynos_fb.c
index ed0823b..c3606d5 100644
--- a/drivers/video/exynos_fb.c
+++ b/drivers/video/exynos_fb.c
@@ -319,10 +319,10 @@
#ifdef CONFIG_OF_CONTROL
if (exynos_fimd_parse_dt(gd->fdt_blob))
debug("Can't get proper panel info\n");
-#endif
+#else
/* initialize parameters which is specific to panel. */
init_panel_info(&panel_info);
-
+#endif
panel_width = panel_info.vl_width;
panel_height = panel_info.vl_height;