powerpc/mpc85xx: Remove QE firmware copy from NAND
qe_init() does not use data copied from NAND. Thise code is not tested or
complied causing compilation error during NAND boot
So, remove QE firmware copy from NAND to ddr.
Signed-off-by: Prabhakar Kushwaha <prabhakar@freescale.com>
Reviewed-by: York Sun <yorksun@freescale.com>
diff --git a/arch/powerpc/cpu/mpc85xx/cpu_init.c b/arch/powerpc/cpu/mpc85xx/cpu_init.c
index 867abb6..a2b79cc 100644
--- a/arch/powerpc/cpu/mpc85xx/cpu_init.c
+++ b/arch/powerpc/cpu/mpc85xx/cpu_init.c
@@ -899,19 +899,6 @@
#endif
#ifdef CONFIG_QE
-#ifdef CONFIG_SYS_QE_FMAN_FW_IN_NAND
- int ret;
- size_t fw_length = CONFIG_SYS_QE_FMAN_FW_LENGTH;
-
- /* load QE firmware from NAND flash to DDR first */
- ret = nand_read(&nand_info[0], (loff_t)CONFIG_SYS_QE_FMAN_FW_IN_NAND,
- &fw_length, (u_char *)CONFIG_SYS_QE_FW_ADDR);
-
- if (ret && ret == -EUCLEAN) {
- printf ("NAND read for QE firmware at offset %x failed %d\n",
- CONFIG_SYS_QE_FMAN_FW_IN_NAND, ret);
- }
-#endif
qe_init(qe_base);
qe_reset();
#endif