ppc4xx: Remove 4xx NAND booting support
As ppc4xx currently only supports the deprecated nand_spl infrastructure
and nobody seems to have time / resources to port this over to the newer
SPL infrastructure, lets remove NAND booting completely.
This should not affect the "normal", non NAND-booting ppc4xx platforms
that are currently supported.
Signed-off-by: Stefan Roese <sr@denx.de>
Cc: Wolfgang Denk <wd@denx.de>
Cc: Tirumala Marri <tmarri@apm.com>
Cc: Matthias Fuchs <matthias.fuchs@esd.eu>
Cc: Masahiro Yamada <yamada.m@jp.panasonic.com>
Cc: Tom Rini <trini@ti.com>
Tested-by: Matthias Fuchs <matthias.fuchs@esd.eu>
diff --git a/board/amcc/sequoia/sdram.c b/board/amcc/sequoia/sdram.c
index 2c5a218..67640d7 100644
--- a/board/amcc/sequoia/sdram.c
+++ b/board/amcc/sequoia/sdram.c
@@ -26,14 +26,6 @@
extern int denali_wait_for_dlllock(void);
extern void denali_core_search_data_eye(void);
-#if defined(CONFIG_NAND_SPL)
-/* Using arch/powerpc/cpu/ppc4xx/speed.c to calculate the bus frequency is too big
- * for the 4k NAND boot image so define bus_frequency to 133MHz here
- * which is save for the refresh counter setup.
- */
-#define get_bus_freq(val) 133333333
-#endif
-
/*************************************************************************
*
* initdram -- 440EPx's DDR controller is a DENALI Core
@@ -41,8 +33,7 @@
************************************************************************/
phys_size_t initdram (int board_type)
{
-#if !(defined(CONFIG_NAND_U_BOOT) || defined(CONFIG_SYS_RAMBOOT)) || \
- defined(CONFIG_NAND_SPL)
+#if !defined(CONFIG_SYS_RAMBOOT)
ulong speed = get_bus_freq(0);
mtsdram(DDR0_02, 0x00000000);
@@ -81,7 +72,7 @@
mtsdram(DDR0_02, 0x00000001);
denali_wait_for_dlllock();
-#endif /* #ifndef CONFIG_NAND_U_BOOT */
+#endif /* #ifndef CONFIG_SYS_RAMBOOT */
#ifdef CONFIG_DDR_DATA_EYE
/* -----------------------------------------------------------+