mpc83xx_clk: always treat MPC83XX_CLK_PCI as invalid
The current mpc83xx_clk driver is broken for any board for which
mpc83xx_has_pci() is true, i.e. anything not MPC8308:
When is_clk_valid() reports that MPC83XX_CLK_PCI is valid,
init_all_clks() proceeds to call init_single_clk(), but that doesn't
know about either MPC83XX_CLK_PCI or has any handling of the
TYPE_SCCR_ONOFF mode correctly returned by retrieve_mode(). Hence
init_single_clk() ends up returning -EINVAL, and the whole board hangs
in serial_init().
The quickest fix is to simply pretend that clock is invalid for
all, since nobody can have been relying on it. Adding proper support
seems to be a bit more involved than just handling TYPE_SCCR_ONOFF:
- The power-on-reset value of SCCR[PCICM] is 0, so
mpc83xx_clk_enable() would probably need to be tought to enable the
clock.
- The frequency of PCI_SYNC_OUT is either SYS_CLK_IN or SYS_CLK_IN/2
depending on the CFG_CLKIN_DIV configuration input, but that can't
be read from software, so to properly fill out
->speed[MPC83XX_CLK_PCI] I think one would need guidance from
Kconfig or dtb.
Partially fixes: 07d538d281 clk: Add MPC83xx clock driver
Signed-off-by: Rasmus Villemoes <rasmus.villemoes@prevas.dk>
Reviewed-by: Mario Six <mario.six@gdsys.cc>
diff --git a/drivers/clk/mpc83xx_clk.c b/drivers/clk/mpc83xx_clk.c
index cbccda5..69c6207 100644
--- a/drivers/clk/mpc83xx_clk.c
+++ b/drivers/clk/mpc83xx_clk.c
@@ -66,7 +66,10 @@
case MPC83XX_CLK_DMAC:
return (type == SOC_MPC8308) || (type == SOC_MPC8309);
case MPC83XX_CLK_PCI:
- return mpc83xx_has_pci(type);
+ /*
+ * FIXME: implement proper support for this.
+ */
+ return 0 && mpc83xx_has_pci(type);
case MPC83XX_CLK_CSB:
return true;
case MPC83XX_CLK_I2C2: