serial: bcm283x_mu: Detect disabled serial device
On the raspberry pi, you can disable the serial port to gain dynamic frequency
scaling which can get handy at times.
However, in such a configuration the serial controller gets its rx queue filled
up with zero bytes which then happily get transmitted on to whoever calls
getc() today.
This patch adds detection logic for that case by checking whether the RX pin is
mapped to GPIO15 and disables the mini uart if it is not mapped properly.
That way we can leave the driver enabled in the tree and can determine during
runtime whether serial is usable or not, having a single binary that allows for
uart and non-uart operation.
Signed-off-by: Alexander Graf <agraf@suse.de>
Acked-by: Stephen Warren <swarren@wwwdotorg.org>
Reviewed-by: Simon Glass <sjg@chromium.org>
diff --git a/include/configs/rpi.h b/include/configs/rpi.h
index 752cc31..e34814b 100644
--- a/include/configs/rpi.h
+++ b/include/configs/rpi.h
@@ -16,6 +16,7 @@
/* Architecture, CPU, etc.*/
#define CONFIG_ARCH_CPU_INIT
+#define CONFIG_BOARD_EARLY_INIT_F
/* Use SoC timer for AArch32, but architected timer for AArch64 */
#ifndef CONFIG_ARM64