pinctrl: nxp: add a pin controller driver based on SCMI pin control protocol
This patch provides a pinctrl driver based on SCMI pin control protocol.
Currently, only the PINCTRL_CONFIG_SET command is implemented.
Signed-off-by: Ranjani Vaidyanathan <Ranjani.Vaidyanathan@nxp.com>
Signed-off-by: Peng Fan <peng.fan@nxp.com>
Signed-off-by: Alice Guo <alice.guo@nxp.com>
Reviewed-by: Ye Li <ye.li@nxp.com>
diff --git a/include/scmi_protocols.h b/include/scmi_protocols.h
index 7abb2a6..279ebba 100644
--- a/include/scmi_protocols.h
+++ b/include/scmi_protocols.h
@@ -24,6 +24,7 @@
SCMI_PROTOCOL_ID_SENSOR = 0x15,
SCMI_PROTOCOL_ID_RESET_DOMAIN = 0x16,
SCMI_PROTOCOL_ID_VOLTAGE_DOMAIN = 0x17,
+ SCMI_PROTOCOL_ID_PINCTRL = 0x19,
};
enum scmi_status_code {
@@ -1005,4 +1006,39 @@
s32 voltage_level;
};
+/* SCMI Pinctrl Protocol */
+enum scmi_pinctrl_message_id {
+ SCMI_MSG_PINCTRL_CONFIG_SET = 0x6
+};
+
+struct scmi_pin_config {
+ u32 type;
+ u32 val;
+};
+
+/**
+ * struct scmi_pad_config_set_in - Message payload for PAD_CONFIG_SET command
+ * @identifier: Identifier for the pin or group.
+ * @function_id: Identifier for the function selected to be enabled
+ * for the selected pin or group. This field is set to
+ * 0xFFFFFFFF if no function should be enabled by the
+ * pin or group.
+ * @attributes: Bits[31:11] Reserved, must be zero.
+ * Bit[10] Function valid.
+ * Bits[9:2] Number of configurations to set.
+ * Bits[1:0] Selector: Whether the identifier field
+ * refers to a pin or a group.
+ * @configs: Array of configurations.
+ */
+struct scmi_pinctrl_config_set_in {
+ u32 identifier;
+ u32 function_id;
+ u32 attributes;
+ struct scmi_pin_config configs[4];
+};
+
+struct scmi_pinctrl_config_set_out {
+ s32 status;
+};
+
#endif /* _SCMI_PROTOCOLS_H */