spi: ti_qspi: Fix failure on multiple READ_ID cmd
Populating QSPI_RD_SNGL bit(0x1) in priv->cmd means that value
QSPI_INVAL (0x4) is not written to CMD field of QSPI_SPI_CMD_REG in
ti_qspi_cs_deactivate(). Therefore CS is never deactivated between
successive READ ID which results in sf probe to fail.
Fix this by not populating priv->cmd with QSPI_RD_SNGL and OR it wih
priv->cmd as required (similar to the convention followed in the
driver).
Signed-off-by: Vignesh R <vigneshr@ti.com>
Reviewed-by: Jagan Teki <jteki@openedev.com>
Reviewed-by: Mugunthan V N <mugunthanvnm@ti.com>
diff --git a/drivers/spi/ti_qspi.c b/drivers/spi/ti_qspi.c
index 9a372ad..a850aa2 100644
--- a/drivers/spi/ti_qspi.c
+++ b/drivers/spi/ti_qspi.c
@@ -247,13 +247,12 @@
debug("tx done, status %08x\n", status);
}
if (rxp) {
- priv->cmd |= QSPI_RD_SNGL;
debug("rx cmd %08x dc %08x\n",
- priv->cmd, priv->dc);
+ ((u32)(priv->cmd | QSPI_RD_SNGL)), priv->dc);
#ifdef CONFIG_DRA7XX
udelay(500);
#endif
- writel(priv->cmd, &priv->base->cmd);
+ writel(priv->cmd | QSPI_RD_SNGL, &priv->base->cmd);
status = readl(&priv->base->status);
timeout = QSPI_TIMEOUT;
while ((status & QSPI_WC_BUSY) != QSPI_XFER_DONE) {