rockchip: Fix SPL console output when ROCKCHIP_SPL_BACK_TO_BROM is enabled
Move back_to_bootrom() call later in SPL init so that the console is
initialized and printouts happen.
Currently when ROCKCHIP_SPL_BACK_TO_BROM is enabled there is no console
output from the SPL init stages.
I wasn't sure exactly where this should happen, so if we are set to do
run spl_board_init, then go back to bootrom there after
preloader_console_init(). Otherwise fall back to old behavior of doing
it in board_init_f.
Signed-off-by: Sandy Patterson <apatterson@sightlogix.com>
Acked-by: Ziyuan Xu <xzy.xu@rock-chips.com>
Acked-by: Simon Glass <sjg@chromium.org>
diff --git a/arch/arm/mach-rockchip/rk3288-board-spl.c b/arch/arm/mach-rockchip/rk3288-board-spl.c
index ae509ff..0f40351 100644
--- a/arch/arm/mach-rockchip/rk3288-board-spl.c
+++ b/arch/arm/mach-rockchip/rk3288-board-spl.c
@@ -206,7 +206,7 @@
debug("DRAM init failed: %d\n", ret);
return;
}
-#ifdef CONFIG_ROCKCHIP_SPL_BACK_TO_BROM
+#if defined(CONFIG_ROCKCHIP_SPL_BACK_TO_BROM) && !defined(CONFIG_SPL_BOARD_INIT)
back_to_bootrom();
#endif
}
@@ -273,6 +273,9 @@
}
preloader_console_init();
+#ifdef CONFIG_ROCKCHIP_SPL_BACK_TO_BROM
+ back_to_bootrom();
+#endif
return;
err:
printf("spl_board_init: Error %d\n", ret);