lib: optee: remove the duplicate CONFIG_OPTEE
The configuration CONFIG_OPTEE is defined 2 times:
1- in lib/optee/Kconfig for support of OPTEE images loaded by bootm command
2- in drivers/tee/optee/Kconfig for support of OP-TEE driver.
It is abnormal to have the same CONFIG define for 2 purpose;
and it is difficult to managed correctly their dependencies.
Moreover CONFIG_SPL_OPTEE is defined in common/spl/Kconfig
to manage OPTEE image load in SPL.
This definition causes an issue with the macro CONFIG_IS_ENABLED(OPTEE)
to test the availability of the OP-TEE driver.
This patch cleans the configuration dependency with:
- CONFIG_OPTEE_IMAGE (renamed) => support of OP-TEE image in U-Boot
- CONFIG_SPL_OPTEE_IMAGE (renamed) => support of OP-TEE image in SPL
- CONFIG_OPTEE (same) => support of OP-TEE driver in U-Boot
- CONFIG_OPTEE_LIB (new) => support of OP-TEE library
After this patch, the macro have the correct behavior:
- CONFIG_IS_ENABLED(OPTEE_IMAGE) => Load of OP-TEE image is supported
- CONFIG_IS_ENABLED(OPTEE) => OP-TEE driver is supported
Signed-off-by: Patrick Delaunay <patrick.delaunay@foss.st.com>
diff --git a/lib/optee/Kconfig b/lib/optee/Kconfig
index 3290b66..3072c28 100644
--- a/lib/optee/Kconfig
+++ b/lib/optee/Kconfig
@@ -1,23 +1,27 @@
-config OPTEE
+config OPTEE_LIB
+ bool "Support OPTEE library"
+ default y if OPTEE || OPTEE_IMAGE
+ help
+ Selecting this option will enable the shared OPTEE library code.
+
+config OPTEE_IMAGE
bool "Support OPTEE images"
help
- U-Boot can be configured to boot OPTEE images.
- Selecting this option will enable shared OPTEE library code and
- enable an OPTEE specific bootm command that will perform additional
- OPTEE specific checks before booting an OPTEE image created with
- mkimage.
+ Selecting this option to boot OPTEE images.
+ This option enable the OPTEE specific checks done before booting
+ an OPTEE image created with mkimage
config OPTEE_LOAD_ADDR
hex "OPTEE load address"
default 0x00000000
- depends on OPTEE
+ depends on OPTEE_LIB
help
The load address of the bootable OPTEE binary.
config OPTEE_TZDRAM_SIZE
hex "Amount of Trust-Zone RAM for the OPTEE image"
default 0x0000000
- depends on OPTEE
+ depends on OPTEE_LIB
help
The size of pre-allocated Trust Zone DRAM to allocate for the OPTEE
runtime.
@@ -25,7 +29,7 @@
config OPTEE_TZDRAM_BASE
hex "Base address of Trust-Zone RAM for the OPTEE image"
default 0x00000000
- depends on OPTEE
+ depends on OPTEE_LIB
help
The base address of pre-allocated Trust Zone DRAM for
the OPTEE runtime.
@@ -33,7 +37,7 @@
config BOOTM_OPTEE
bool "Support OPTEE bootm command"
select BOOTM_LINUX
- depends on OPTEE
+ select OPTEE_IMAGE
help
Select this command to enable chain-loading of a Linux kernel
via an OPTEE firmware.