arm: j721e: Add support for selecting DT based on board name
Enable support for selecting DTB from FIT within SPL based on the
board name read from EEPROM. This will help to use single defconfig
for both EVM and SK.
Signed-off-by: Sinthu Raja <sinthu.raja@ti.com>
diff --git a/arch/arm/mach-k3/j721e_init.c b/arch/arm/mach-k3/j721e_init.c
index 78d80be..c4b6b18 100644
--- a/arch/arm/mach-k3/j721e_init.c
+++ b/arch/arm/mach-k3/j721e_init.c
@@ -19,6 +19,8 @@
#include <dm.h>
#include <dm/uclass-internal.h>
#include <dm/pinctrl.h>
+#include <dm/root.h>
+#include <fdtdec.h>
#include <mmc.h>
#include <remoteproc.h>
@@ -135,6 +137,59 @@
sizeof(struct rom_extended_boot_data));
}
+#ifdef CONFIG_SPL_OF_LIST
+void do_dt_magic(void)
+{
+ int ret, rescan, mmc_dev = -1;
+ static struct mmc *mmc;
+
+ if (IS_ENABLED(CONFIG_TI_I2C_BOARD_DETECT))
+ do_board_detect();
+
+ /*
+ * Board detection has been done.
+ * Let us see if another dtb wouldn't be a better match
+ * for our board
+ */
+ if (IS_ENABLED(CONFIG_CPU_V7R)) {
+ ret = fdtdec_resetup(&rescan);
+ if (!ret && rescan) {
+ dm_uninit();
+ dm_init_and_scan(true);
+ }
+ }
+
+ /*
+ * Because of multi DTB configuration, the MMC device has
+ * to be re-initialized after reconfiguring FDT inorder to
+ * boot from MMC. Do this when boot mode is MMC and ROM has
+ * not loaded SYSFW.
+ */
+ switch (spl_boot_device()) {
+ case BOOT_DEVICE_MMC1:
+ mmc_dev = 0;
+ break;
+ case BOOT_DEVICE_MMC2:
+ case BOOT_DEVICE_MMC2_2:
+ mmc_dev = 1;
+ break;
+ }
+
+ if (mmc_dev > 0 && !is_rom_loaded_sysfw(&bootdata)) {
+ ret = mmc_init_device(mmc_dev);
+ if (!ret) {
+ mmc = find_mmc_device(mmc_dev);
+ if (mmc) {
+ ret = mmc_init(mmc);
+ if (ret) {
+ printf("mmc init failed with error: %d\n", ret);
+ }
+ }
+ }
+ }
+}
+#endif
+
void board_init_f(ulong dummy)
{
#if defined(CONFIG_K3_J721E_DDRSS) || defined(CONFIG_K3_LOAD_SYSFW)
@@ -180,6 +235,10 @@
k3_sysfw_loader(is_rom_loaded_sysfw(&bootdata),
k3_mmc_stop_clock, k3_mmc_restart_clock);
+#ifdef CONFIG_SPL_OF_LIST
+ do_dt_magic();
+#endif
+
/*
* Force probe of clk_k3 driver here to ensure basic default clock
* configuration is always done.