ARMV7: OMAP3: Remove erroneous hard coded sdram setup for 128MB/bank
Upcoming Beagle and Overo revisions use POP memory with 256MB or 512MB
per bank. This patches uses the SDRC settings from x-load or the config
header to set up timing properly.
Signed-off-by: Steve Sakoman <steve@sakoman.com>
Signed-off-by: Sandeep Paulraj <s-paulraj@ti.com>
diff --git a/arch/arm/cpu/armv7/omap3/sdrc.c b/arch/arm/cpu/armv7/omap3/sdrc.c
index 96fd990c..8905224 100644
--- a/arch/arm/cpu/armv7/omap3/sdrc.c
+++ b/arch/arm/cpu/armv7/omap3/sdrc.c
@@ -107,18 +107,12 @@
/*
* do_sdrc_init -
* - Initialize the SDRAM for use.
- * - Sets up SDRC timings for CS0
* - code called once in C-Stack only context for CS0 and a possible 2nd
* time depending on memory configuration from stack+global context
*/
void do_sdrc_init(u32 cs, u32 early)
{
- struct sdrc_actim *sdrc_actim_base;
-
- if (cs)
- sdrc_actim_base = (struct sdrc_actim *)SDRC_ACTIM_CTRL1_BASE;
- else
- sdrc_actim_base = (struct sdrc_actim *)SDRC_ACTIM_CTRL0_BASE;
+ struct sdrc_actim *sdrc_actim_base0, *sdrc_actim_base1;
if (early) {
/* reset sdrc controller */
@@ -138,24 +132,29 @@
sdelay(0x20000);
}
- writel(RASWIDTH_13BITS | CASWIDTH_10BITS | ADDRMUXLEGACY |
- RAMSIZE_128 | BANKALLOCATION | B32NOT16 | B32NOT16 |
- DEEPPD | DDR_SDRAM, &sdrc_base->cs[cs].mcfg);
- writel(ARCV | ARE_ARCV_1, &sdrc_base->cs[cs].rfr_ctrl);
- writel(V_ACTIMA_165, &sdrc_actim_base->ctrla);
- writel(V_ACTIMB_165, &sdrc_actim_base->ctrlb);
-
- writel(CMD_NOP, &sdrc_base->cs[cs].manual);
- writel(CMD_PRECHARGE, &sdrc_base->cs[cs].manual);
- writel(CMD_AUTOREFRESH, &sdrc_base->cs[cs].manual);
- writel(CMD_AUTOREFRESH, &sdrc_base->cs[cs].manual);
-
/*
- * CAS latency 3, Write Burst = Read Burst, Serial Mode,
- * Burst length = 4
+ * SDRC timings are set up by x-load or config header
+ * We don't need to redo them here.
+ * Older x-loads configure only CS0
+ * configure CS1 to handle this ommission
*/
- writel(CASL3 | BURSTLENGTH4, &sdrc_base->cs[cs].mr);
+ if (cs) {
+ sdrc_actim_base0 = (struct sdrc_actim *)SDRC_ACTIM_CTRL0_BASE;
+ sdrc_actim_base1 = (struct sdrc_actim *)SDRC_ACTIM_CTRL1_BASE;
+ writel(readl(&sdrc_base->cs[CS0].mcfg),
+ &sdrc_base->cs[CS1].mcfg);
+ writel(readl(&sdrc_base->cs[CS0].rfr_ctrl),
+ &sdrc_base->cs[CS1].rfr_ctrl);
+ writel(readl(&sdrc_actim_base0->ctrla),
+ &sdrc_actim_base1->ctrla);
+ writel(readl(&sdrc_actim_base0->ctrlb),
+ &sdrc_actim_base1->ctrlb);
+ }
+ /*
+ * Test ram in this bank
+ * Disable if bad or not present
+ */
if (!mem_ok(cs))
writel(0, &sdrc_base->cs[cs].mcfg);
}