imx: ventana: export backlight gpio after gpio driver is available
Calling request_gpio to register bklt_gpio with the GPIO driver had no effect
in setup_display called from early board init (although pinmuxing it and
configuring it as output-low does do what it should). Therefore move the
request_gpio later in enable_lvds so that its registered for use by the
gpio command if LVDS is actually enabled.
Signed-off-by: Tim Harvey <tharvey@gateworks.com>
diff --git a/board/gateworks/gw_ventana/gw_ventana.c b/board/gateworks/gw_ventana/gw_ventana.c
index 3b7c82b..7a3d96a 100644
--- a/board/gateworks/gw_ventana/gw_ventana.c
+++ b/board/gateworks/gw_ventana/gw_ventana.c
@@ -317,6 +317,8 @@
writel(reg, &iomux->gpr[2]);
/* Enable Backlight */
+ gpio_request(IMX_GPIO_NR(1, 10), "bklt_gpio");
+ gpio_direction_output(IMX_GPIO_NR(1, 10), 0);
gpio_request(IMX_GPIO_NR(1, 18), "bklt_en");
SETUP_IOMUX_PAD(PAD_SD1_CMD__GPIO1_IO18 | DIO_PAD_CFG);
gpio_direction_output(IMX_GPIO_NR(1, 18), 1);
@@ -456,8 +458,7 @@
<<IOMUXC_GPR3_LVDS0_MUX_CTL_OFFSET);
writel(reg, &iomux->gpr[3]);
- /* Backlight CABEN on LVDS connector */
- gpio_request(IMX_GPIO_NR(1, 10), "bklt_gpio");
+ /* LVDS Backlight GPIO on LVDS connector - output low */
SETUP_IOMUX_PAD(PAD_SD2_CLK__GPIO1_IO10 | DIO_PAD_CFG);
gpio_direction_output(IMX_GPIO_NR(1, 10), 0);
}