net: xilinx_axi: Clear Isolate bit if found during phy setup
In SGMII cases the isolate bit might set after DMA and
ethernet resets and hence check and clear during
setup_phy if it was set.
Signed-off-by: Siva Durga Prasad Paladugu <sivadur@xilinx.com>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>
diff --git a/drivers/net/xilinx_axi_emac.c b/drivers/net/xilinx_axi_emac.c
index 46b8d2d..3d69bed 100644
--- a/drivers/net/xilinx_axi_emac.c
+++ b/drivers/net/xilinx_axi_emac.c
@@ -264,11 +264,29 @@
/* Setting axi emac and phy to proper setting */
static int setup_phy(struct udevice *dev)
{
- u32 speed, emmc_reg;
+ u16 temp;
+ u32 speed, emmc_reg, ret;
struct axidma_priv *priv = dev_get_priv(dev);
struct axi_regs *regs = priv->iobase;
struct phy_device *phydev = priv->phydev;
+ if (priv->interface == PHY_INTERFACE_MODE_SGMII) {
+ /*
+ * In SGMII cases the isolate bit might set
+ * after DMA and ethernet resets and hence
+ * check and clear if set.
+ */
+ ret = phyread(priv, priv->phyaddr, MII_BMCR, &temp);
+ if (ret)
+ return 0;
+ if (temp & BMCR_ISOLATE) {
+ temp &= ~BMCR_ISOLATE;
+ ret = phywrite(priv, priv->phyaddr, MII_BMCR, temp);
+ if (ret)
+ return 0;
+ }
+ }
+
if (phy_startup(phydev)) {
printf("axiemac: could not initialize PHY %s\n",
phydev->dev->name);