designware_i2c: Enhance DesignWare I2C driver address support
Enhance the DesignWare I2C driver to support address length more
than 1 byte. This enhancement is required as some I2C slave
device such as EEPROM chip might have 16 bit address byte.
Signed-off-by: Chin Liang See <clsee@altera.com>
Acked-by: Alexey Brodkin <Alexey.Brodkin@synopsys.com>
Cc: Tom Rini <trini@ti.com>
cc: Armando Visconti <armando.visconti@st.com>
Cc: Stefan Roese <sr@denx.de>
Cc: Albert ARIBAUD <albert.u.boot@aribaud.net>
Cc: Heiko Schocher <hs@denx.de>
diff --git a/drivers/i2c/designware_i2c.c b/drivers/i2c/designware_i2c.c
index 9ed9295..deea4f8 100644
--- a/drivers/i2c/designware_i2c.c
+++ b/drivers/i2c/designware_i2c.c
@@ -197,35 +197,18 @@
return 0;
}
-/* check parameters for i2c_read and i2c_write */
-static int check_params(uint addr, int alen, uchar *buffer, int len)
-{
- if (buffer == NULL) {
- printf("Buffer is invalid\n");
- return 1;
- }
-
- if (alen > 1) {
- printf("addr len %d not supported\n", alen);
- return 1;
- }
-
- if (addr + len > 256) {
- printf("address out of range\n");
- return 1;
- }
-
- return 0;
-}
-
-static int i2c_xfer_init(uchar chip, uint addr)
+static int i2c_xfer_init(uchar chip, uint addr, int alen)
{
if (i2c_wait_for_bb())
return 1;
i2c_setaddress(chip);
- writel(addr, &i2c_regs_p->ic_cmd_data);
-
+ while (alen) {
+ alen--;
+ /* high byte address going out first */
+ writel((addr >> (alen * 8)) & 0xff,
+ &i2c_regs_p->ic_cmd_data);
+ }
return 0;
}
@@ -285,12 +268,9 @@
addr);
#endif
- if (check_params(addr, alen, buffer, len))
+ if (i2c_xfer_init(chip, addr, alen))
return 1;
- if (i2c_xfer_init(chip, addr))
- return 1;
-
start_time_rx = get_timer(0);
while (len) {
if (len == 1)
@@ -345,10 +325,7 @@
addr);
#endif
- if (check_params(addr, alen, buffer, len))
- return 1;
-
- if (i2c_xfer_init(chip, addr))
+ if (i2c_xfer_init(chip, addr, alen))
return 1;
start_time_tx = get_timer(0);