mtd: cfi: respect reg address length
flash_get_size() will get the flash size from the device itself and go
through all erase regions to read protection status. However, the device
mappable region (eg: devicetree reg property) might be lower than the
device full size which means that the above cycle will result in a data
bus exception. This change fixes it by reading the 'addr_size' during
probe() and also use that as one possible upper limit.
Signed-off-by: Nuno Sá <nuno.sa@analog.com>
diff --git a/drivers/mtd/cfi_flash.c b/drivers/mtd/cfi_flash.c
index f378f6f..8ade794 100644
--- a/drivers/mtd/cfi_flash.c
+++ b/drivers/mtd/cfi_flash.c
@@ -2196,6 +2196,12 @@
/* multiply the size by the number of chips */
info->size *= size_ratio;
max_size = cfi_flash_bank_size(banknum);
+#ifdef CONFIG_CFI_FLASH
+ if (max_size)
+ max_size = min((unsigned long)info->addr_size, max_size);
+ else
+ max_size = info->addr_size;
+#endif
if (max_size && info->size > max_size) {
debug("[truncated from %ldMiB]", info->size >> 20);
info->size = max_size;
@@ -2492,15 +2498,17 @@
static int cfi_flash_probe(struct udevice *dev)
{
fdt_addr_t addr;
+ fdt_size_t size;
int idx;
for (idx = 0; idx < CFI_MAX_FLASH_BANKS; idx++) {
- addr = dev_read_addr_index(dev, idx);
+ addr = dev_read_addr_size_index(dev, idx, &size);
if (addr == FDT_ADDR_T_NONE)
break;
flash_info[cfi_flash_num_flash_banks].dev = dev;
flash_info[cfi_flash_num_flash_banks].base = addr;
+ flash_info[cfi_flash_num_flash_banks].addr_size = size;
cfi_flash_num_flash_banks++;
}
gd->bd->bi_flashstart = flash_info[0].base;
diff --git a/include/flash.h b/include/flash.h
index 95992fa..3710a27 100644
--- a/include/flash.h
+++ b/include/flash.h
@@ -46,6 +46,7 @@
#ifdef CONFIG_CFI_FLASH /* DM-specific parts */
struct udevice *dev;
phys_addr_t base;
+ phys_size_t addr_size;
#endif
} flash_info_t;