sunxi: Turn satapwr on from board_init
There are 2 reasons for doing this:
1) The main reason for doing this is to move it outside of
board/sunxi/ahci.c, so that it can be used on boards which use
a usb<->sata chip too;
2) While doing this I realized that doing it from board_init also meant
doing it much earlier. Some printf get_timer(0) calls show that the
time between board_init() and scsi_init() is more then 600 ms,
so we can drop the mdelay(500)
While at it also drop the printf("SUNXI SCSI INIT\n") AHCI init is
noisy enough by itself.
Signed-off-by: Hans de Goede <hdegoede@redhat.com>
Acked-by: Ian Campbell <ijc@hellion.org.uk>
diff --git a/board/sunxi/ahci.c b/board/sunxi/ahci.c
index 6d51b9b..522e54a 100644
--- a/board/sunxi/ahci.c
+++ b/board/sunxi/ahci.c
@@ -72,14 +72,6 @@
void scsi_init(void)
{
- printf("SUNXI SCSI INIT\n");
-#ifdef CONFIG_SATAPWR
- gpio_request(CONFIG_SATAPWR, "satapwr");
- gpio_direction_output(CONFIG_SATAPWR, 1);
- /* Give attached sata device time to power-up to avoid link timeouts */
- mdelay(500);
-#endif
-
if (sunxi_ahci_phy_init(SUNXI_SATA_BASE) < 0)
return;
diff --git a/board/sunxi/board.c b/board/sunxi/board.c
index e16718f..2e2a1f5 100644
--- a/board/sunxi/board.c
+++ b/board/sunxi/board.c
@@ -90,6 +90,10 @@
if (ret)
return ret;
+#ifdef CONFIG_SATAPWR
+ gpio_request(CONFIG_SATAPWR, "satapwr");
+ gpio_direction_output(CONFIG_SATAPWR, 1);
+#endif
#ifdef CONFIG_MACPWR
gpio_request(CONFIG_MACPWR, "macpwr");
gpio_direction_output(CONFIG_MACPWR, 1);