arm: mach-k3: do board config for PM only if supported
If the raw PM support is built in, we are operating in the split
firmware approach mode where PM support is not available. In this
case, skip the board config for this.
Signed-off-by: Tero Kristo <t-kristo@ti.com>
Signed-off-by: Tero Kristo <kristo@kernel.org>
diff --git a/arch/arm/mach-k3/sysfw-loader.c b/arch/arm/mach-k3/sysfw-loader.c
index 0bacfc4..41449db 100644
--- a/arch/arm/mach-k3/sysfw-loader.c
+++ b/arch/arm/mach-k3/sysfw-loader.c
@@ -159,11 +159,13 @@
ret);
/* Apply power/clock (PM) specific configuration to SYSFW */
+#if !CONFIG_IS_ENABLED(K3_DM_FW)
ret = board_ops->board_config_pm(ti_sci,
(u64)(u32)cfg_fragment_addr,
(u32)cfg_fragment_size);
if (ret)
panic("Failed to set board PM configuration (%d)\n", ret);
+#endif
/* Extract resource management (RM) specific configuration from FIT */
ret = fit_get_data_by_name(fit, images, SYSFW_CFG_RM,