sunxi: pinephone: detect existed magnetometer and fixup dtb
In newer 1.2 PinePhone board revisions LIS3MDL magnetometer was replaced by
AF8133J. They use the same PB1 pin in different modes.
LIS3MDL uses it as an gpio input to handle interrupt.
AF8133J uses it as an gpio output as a reset signal.
It wasn't possible at runtime to enable both device tree
nodes and detect supported sensor at probe time.
AF8133J has reset pin (PB1) connected to the SoC. By default AF8133J
is in a reset state and don't respond to probe request on I2C
bus. Extra code would be needed to handle reset signal. Therefore this
code uses LIS3MDL magnetometer instead of AF8133J.
Introducing new dts 1.2b with AF8133J sensor would require probing in
SPL. That would lead to pulling in into SPL I2C controller driver,
RSB controller driver, introducing new AXP803 driver to power-up
sensors for probe. It's working, but SPL is pretty size-constrained on
A64 and doesn't have much space. Therefore fdt fixup is done in U-Boot
proper without introducing new board revision and new dts.
Signed-off-by: Andrey Skvortsov <andrej.skvortzov@gmail.com>
Link: https://lore.kernel.org/all/20240908214718.36316-1-andrej.skvortzov@gmail.com/
Link: https://lists.denx.de/pipermail/u-boot/2024-February/545700.html
Reviewed-by: Andre Przywara <andre.przywara@arm.com>
[Andre: fix formatting]
Signed-off-by: Andre Przywara <andre.przywara@arm.com>
2 files changed