mpc5200: a3m071/a4m2k: Miscellaneous updates and fixes
The changes to a3m071/a4m2k in summary are:
- Enable CAN1 on I2C in GPS Port Configuration
- Enable SPI on PSC2
- Activate network console
- New flash partitioning
- Fix some typos
- Pass host name to Linux
- Change rootfs to squashfs,jffs2
- Enable UBI/UBIFS support
- Enable FIT support
Signed-off-by: Stefan Roese <sr@denx.de>
diff --git a/board/a3m071/a3m071.c b/board/a3m071/a3m071.c
index 0f9f883..c62ba62 100644
--- a/board/a3m071/a3m071.c
+++ b/board/a3m071/a3m071.c
@@ -8,7 +8,7 @@
* (C) Copyright 2006
* MicroSys GmbH
*
- * Copyright 2012 Stefan Roese <sr@denx.de>
+ * Copyright 2012-2013 Stefan Roese <sr@denx.de>
*
* See file CREDITS for list of people who contributed to this
* project.
@@ -241,12 +241,26 @@
/* And write new value back to register */
out_be32(&mm->ipbi_ws_ctrl, val);
-#endif
- /*
- * No need to change the pin multiplexing (MPC5XXX_GPS_PORT_CONFIG)
- * as all 3 config versions (failsave level) have the same setup.
- */
+
+ /* Setup pin multiplexing */
+ if (failsavelevel == 2) {
+ /* fpga-version ok */
+#if defined(CONFIG_SYS_GPS_PORT_CONFIG_2)
+ out_be32(&gpio->port_config, CONFIG_SYS_GPS_PORT_CONFIG_2);
+#endif
+ } else if (failsavelevel == 1) {
+ /* digiboard-version ok - fpga not */
+#if defined(CONFIG_SYS_GPS_PORT_CONFIG_1)
+ out_be32(&gpio->port_config, CONFIG_SYS_GPS_PORT_CONFIG_1);
+#endif
+ } else {
+ /* full failsave-mode */
+#if defined(CONFIG_SYS_GPS_PORT_CONFIG)
+ out_be32(&gpio->port_config, CONFIG_SYS_GPS_PORT_CONFIG);
+#endif
+ }
+#endif
/*
* Setup gpio_wkup_7 as watchdog AS INPUT to disable it - see