hwmon: do not init sensors on startup
The U-Boot Design Principles[1] clearly say:
Initialize devices only when they are needed within U-Boot, i.e. don't
initialize the Ethernet interface(s) unless U-Boot performs a download
over Ethernet; don't initialize any IDE or USB devices unless U-Boot
actually tries to load files from these, etc. (and don't forget to
shut down these devices after using them - otherwise nasty things may
happen when you try to boot your OS).
So, do not initialize and read the sensors on startup.
Signed-off-by: Heiko Schocher <hs@denx.de>
cc: Wolfgang Denk <wd@denx.de>
cc: Holger Brunck <holger.brunck@keymile.com>
diff --git a/drivers/hwmon/lm75.c b/drivers/hwmon/lm75.c
index 8119821..29c1a39 100644
--- a/drivers/hwmon/lm75.c
+++ b/drivers/hwmon/lm75.c
@@ -119,7 +119,7 @@
} /* dtt_write() */
-static int _dtt_init(int sensor)
+int dtt_init_one(int sensor)
{
int val;
@@ -145,32 +145,7 @@
return 1;
return 0;
-} /* _dtt_init() */
-
-
-int dtt_init (void)
-{
- int i;
- unsigned char sensors[] = CONFIG_DTT_SENSORS;
- const char *const header = "DTT: ";
- int old_bus;
-
- /* switch to correct I2C bus */
- old_bus = I2C_GET_BUS();
- I2C_SET_BUS(CONFIG_SYS_DTT_BUS_NUM);
-
- for (i = 0; i < sizeof(sensors); i++) {
- if (_dtt_init(sensors[i]) != 0)
- printf("%s%d FAILED INIT\n", header, i+1);
- else
- printf("%s%d is %i C\n", header, i+1,
- dtt_get_temp(sensors[i]));
- }
- /* switch back to original I2C bus */
- I2C_SET_BUS(old_bus);
-
- return (0);
-} /* dtt_init() */
+} /* dtt_init_one() */
int dtt_get_temp(int sensor)
{