drivers: net: fsl_enetc: use write_hwaddr()
Intead of setting the MAC address in enetc_start() use the proper
write_hwaddr(). U-Boot takes care of the random MAC address, too.
Signed-off-by: Michael Walle <michael@walle.cc>
Signed-off-by: Alex Marginean <alexandru.marginean@nxp.com>
Reviewed-by: Priyanka Jain <priyanka.jain@nxp.com>
diff --git a/drivers/net/fsl_enetc.c b/drivers/net/fsl_enetc.c
index f8fe7d4..7c0ed9f 100644
--- a/drivers/net/fsl_enetc.c
+++ b/drivers/net/fsl_enetc.c
@@ -330,14 +330,19 @@
return 0;
}
-/* ENETC Port MAC address registers, accepts big-endian format */
-static void enetc_set_primary_mac_addr(struct enetc_priv *priv, const u8 *addr)
+static int enetc_write_hwaddr(struct udevice *dev)
{
+ struct eth_pdata *plat = dev_get_platdata(dev);
+ struct enetc_priv *priv = dev_get_priv(dev);
+ u8 *addr = plat->enetaddr;
+
u16 lower = *(const u16 *)(addr + 4);
u32 upper = *(const u32 *)addr;
enetc_write_port(priv, ENETC_PSIPMAR0, upper);
enetc_write_port(priv, ENETC_PSIPMAR1, lower);
+
+ return 0;
}
/* Configure port parameters (# of rings, frame size, enable port) */
@@ -468,7 +473,6 @@
*/
static int enetc_start(struct udevice *dev)
{
- struct eth_pdata *plat = dev_get_platdata(dev);
struct enetc_priv *priv = dev_get_priv(dev);
/* reset and enable the PCI device */
@@ -476,12 +480,6 @@
dm_pci_clrset_config16(dev, PCI_COMMAND, 0,
PCI_COMMAND_MEMORY | PCI_COMMAND_MASTER);
- if (!is_valid_ethaddr(plat->enetaddr)) {
- enetc_dbg(dev, "invalid MAC address, generate random ...\n");
- net_random_ethaddr(plat->enetaddr);
- }
- enetc_set_primary_mac_addr(priv, plat->enetaddr);
-
enetc_enable_si_port(priv);
/* setup Tx/Rx buffer descriptors */
@@ -611,6 +609,7 @@
.send = enetc_send,
.recv = enetc_recv,
.stop = enetc_stop,
+ .write_hwaddr = enetc_write_hwaddr,
};
U_BOOT_DRIVER(eth_enetc) = {