Fix INKA4x0: use CS1 as gpio_wkup_6 output
diff --git a/CHANGELOG b/CHANGELOG
index f09948e..aec4650 100644
--- a/CHANGELOG
+++ b/CHANGELOG
@@ -2,6 +2,8 @@
Changes for U-Boot 1.1.3:
======================================================================
+* Fix INKA4x0: use CS1 as gpio_wkup_6 output
+
* Fix bug in the SDRAM initialization code for canmb, IceCube and
PM520 boards.
Fix PHY address for canmb board.
diff --git a/include/configs/inka4x0.h b/include/configs/inka4x0.h
index 82a3842..5cbb0c3 100644
--- a/include/configs/inka4x0.h
+++ b/include/configs/inka4x0.h
@@ -197,8 +197,8 @@
/*
* GPIO configuration
*
- * use pin gpio_wkup_6 as second SDRAM chip select (mem_cs1):
- * Bit 0 (mask: 0x80000000): 1
+ * use CS1 as gpio_wkup_6 output
+ * Bit 0 (mask: 0x80000000): 0
* use ALT CAN position: Bits 2-3 (mask: 0x30000000):
* 00 -> No Alternatives, I2C1 is used for onboard EEPROM
* 01 -> CAN1 on I2C1, CAN2 on Tmr0/1 do not use on TQM5200 with onboard
@@ -206,14 +206,8 @@
* use PSC1 as UART: Bits 28-31 (mask: 0x00000007): 0100
* use PSC6_1 and PSC6_3 as GPIO: Bits 9:11 (mask: 0x07000000):
* 011 -> PSC6 could not be used as UART or CODEC. IrDA still possible.
- * GPIO on PSC6_3 is used in post_hotkeys_pressed() to enable extended POST
- * tests.
*/
-#if defined (CONFIG_MINIFAP)
-#define CFG_GPS_PORT_CONFIG 0x93000004
-#else
-#define CFG_GPS_PORT_CONFIG 0x81001004
-#endif
+#define CFG_GPS_PORT_CONFIG 0x01001004
/*
* RTC configuration