tree 0898ff8f87398b37232879fbe53d609c7b75e5f9
parent 312e15b0b06a7c557b8aba0c2fa273a1b8dc4e19
author Vladimir Oltean <vladimir.oltean@nxp.com> 1611577432 +0200
committer Tom Rini <trini@konsulko.com> 1613494100 -0500

net: phy: introduce fixed_phy_create for DSA CPU ports

The DSA (Distributed Switch Architecture) implementation has made a
design decision when it got introduced to the Linux kernel in 2008.
That was to hide away from the user the CPU-facing Ethernet MAC, since
it does not make sense to register it as a struct net_device (UCLASS_ETH
udevice for U-Boot), because that would never be beneficial for a user:
they would not be able to use it for traffic, since conceptually, a
packet delivered to the CPU port should loop back into the system.

Nonetheless, DSA has had numerous growing pains due to the lack of a
struct net_device for the CPU port, but so far it has overcome them.
It is unlikely at this stage of maturity that this aspect of it will
change.

We would like U-Boot to present the same information as Linux, to be at
parity in terms of number of interfaces, so that ethNaddr environment
variables could directly be associated between U-Boot and Linux.
Therefore, we would implicitly like U-Boot to hide the CPU port from the
user as well.

But the paradox is that DSA still needs a struct phy_device to inform
the driver of the parameters of the link that it should configure the
CPU port to. The problem is that the phy_device is typically returned
via a call to phy_connect, which needs an udevice to attach the PHY to,
and to search its ofnode for the 'fixed-link' property. But we don't
have an udevice to present for the CPU port.

Since 99% of DSA setups are MAC-to-MAC connections between the switch
and the host Ethernet controller, the struct phy_device is going to be a
fixed PHY. This simplifies things quite a bit. In U-Boot, a fixed PHY
does not need an MDIO bus, and does not need an attached dev either.
Basically, the phy_connect call doesn't do any connection, it just
creates the fixed PHY.

The proposal of this patch is to introduce a new fixed_phy_create
function which will take a single argument: the ofnode that holds this:

	port@4 {
		reg = <4>;
		phy-mode = "internal";

		fixed-link {
			speed = <2500>;
			full-duplex;
		};
	};

and probe a fixed PHY driver using the information from this ofnode.
DSA will probably be the only user of this function.

Signed-off-by: Vladimir Oltean <vladimir.oltean@nxp.com>
Reviewed-by: Claudiu Manoil <claudiu.manoil@nxp.com>