sunxi: boards: Enable SPI flash support in U-Boot proper
Some sunxi boards ship with SPI flash, which allows booting through the
BootROM. We cover this functionality by a separate SPL "mini" driver.
Separately we have a proper DM_SPI driver for U-Boot proper, which
provides access to the SPI flash through the "sf" command. That allows
to update the firmware on the SPI flash, also to store the environment
there.
However only very few boards actually enable support for U-Boot proper,
even though that would work and the SPL part is configured.
Use the cleaned up configuration scheme to enable SPI flash on those
boards which mention a SPI flash in their .dts, or which use the SPL SPI
support.
Out of the box this would enable storing the environment on the SPI
flash, and allows people to read or write the flash from U-Boot, for
instance to update the SPI flash when booted via an SD card.
For this to actually work there must be a "spi0" alias in the DT, which
most boards are missing. But this should be addressed separately.
Signed-off-by: Andre Przywara <andre.przywara@arm.com>
Reviewed-by: Jagan Teki <jagan@amarulasolutions.com>
diff --git a/configs/pinecube_defconfig b/configs/pinecube_defconfig
index 0c71d59..e779663 100644
--- a/configs/pinecube_defconfig
+++ b/configs/pinecube_defconfig
@@ -12,8 +12,10 @@
CONFIG_SYS_I2C_MVTWSI=y
CONFIG_SYS_I2C_SLAVE=0x7f
CONFIG_SYS_I2C_SPEED=400000
+CONFIG_SPI_FLASH_WINBOND=y
# CONFIG_NETDEVICES is not set
CONFIG_AXP209_POWER=y
CONFIG_AXP_DCDC2_VOLT=1250
CONFIG_AXP_DCDC3_VOLT=3300
CONFIG_CONS_INDEX=3
+CONFIG_SPI=y